| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 14 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 6 |
| Headlamp aim out of alignment | 5 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 4 |
| Windscreen washer not working | 3 |
| Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 2 |
| Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 2 |
| Emissions not tested (8.2.2.2 (e)) | 2 |
| Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 2 |
| Offside Rear Service brake excessively binding (1.2.1 (f)) | 2 |
| Horn not working (7.7 (a)) | 2 |
| Exhaust emissions exceed default limit of 1.5m-1 (8.2.2.2 (b)) | 2 |
| Rear fog lamp switch inoperative (4.5.3 (a)) | 2 |
| Central Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 2 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 2 |
| Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 2 |
| Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 2 |
| Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength Leaf spring mounting area corroded/holed (rear) (5.3.6 (a) (i)) | 2 |
| Nearside Front Inner Anti-roll bar linkage fractured (5.3.3 (b) (ii)) | 1 |
| Nearside Front Inner Anti-roll bar attachment bracket/mounting fractured (5.3.3 (b) (ii)) | 1 |
| Oil leaking excessively from engine (8.4.1 (a) (i)) | 1 |
| Rear Oil leaking excessively from transmission Rear diff (8.4.1 (a) (i)) | 1 |
| Nearside Front Inner Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Rear Exhaust has a major leak of exhaust gases back box and pipe (6.1.2 (a)) | 1 |
| Spare wheel carrier insecure (6.1.5 (a)) | 1 |
| Front Fuel system component leaking from engine bay (6.1.3 (b) (i)) | 1 |
| Nearside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill panel holed (6.1.1 (c) (i)) | 1 |
| Offside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill panel holed (6.1.1 (c) (i)) | 1 |
| Offside Front Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill panel holed (6.1.1 (c) (i)) | 1 |
| Nearside Rear Upper Shock absorbers has an excessively worn bush (5.3.2 (c)) | 1 |
| Offside Rear Upper Shock absorbers has an excessively worn bush (5.3.2 (c)) | 1 |
| Nearside Front Inner Anti-roll bar pin or bush excessively worn D bush (5.3.4 (a) (i)) | 1 |
| Offside Front Inner Anti-roll bar pin or bush excessively worn D bush (5.3.4 (a) (i)) | 1 |
| Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
| Offside Rear Rear fog lamp likely to become detached (4.5.1 (c) (ii)) | 1 |
| Offside Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b)) | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Nearside Rear Road wheel more than one fixing loose (5.2.1 (a) (ii)) | 1 |
| Rear Rear fog lamp does not emit a steady red light (4.5.4 (a)) | 1 |
| Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Brake pipe excessively corroded | 1 |
| Nearside Front Position lamp light intensity significantly reduced dim (4.2.3 (a) (ii)) | 1 |
| Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Nearside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Nearside Front Steering system fouling pipe rubbing track rod end (2.1.4 (a)) | 1 |
| Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced panel (6.1.1 (c) (i)) | 1 |
| Nearside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced and inner whole sill (6.1.1 (c) (i)) | 1 |
| Front Exhaust emissions likely to be affected by an induction leak (8.2.2.1 (b)) | 1 |
| Nearside Rear Seat belt missing (7.1.2 (a)) | 1 |
| Offside Rear Shock absorbers has an excessively worn bush (5.3.2 (c)) | 1 |
| Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Emissions unable to be completed due to coolant leak (8.2.1.2 (d)) | 1 |
| Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced drivers floor pan (6.1.1 (c) (i)) | 1 |
| Offside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced and inner sill (6.1.1 (c) (i)) | 1 |
| Nearside Rear Shock absorbers has an excessively worn bush (5.3.2 (c)) | 1 |
| Offside Rear Seat belt retracting mechanism defective (7.1.2 (e)) | 1 |
| Nearside Rear Suspension arm attachment bracket/mounting likely to become detached corroded (5.3.3 (a) (ii)) | 1 |
| Offside Rear Suspension arm attachment bracket/mounting likely to fail corroded (5.3.3 (b) (ii)) | 1 |
| Exhaust has a major leak of exhaust gases Flexi pipe (6.1.2 (a)) | 1 |
| Emissions unable to be completed (8.2.1.2 (d)) | 1 |
| Offside Rear Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength OUTER SILL (5.3.6 (a) (i)) | 1 |
| Offside Reversing lamp does not emit a steady white light (4.6.2 (a)) | 1 |
| Offside Stop lamp(s) emits other than a steady red light (4.3.3 (a) (ii)) | 1 |
| Nearside Front Direction indicator adversely affected by the operation of another lamp (4.4.3 (b)) | 1 |
| Offside Front Direction indicator adversely affected by the operation of another lamp (4.4.3 (b)) | 1 |
| Front Exhaust has a major leak of exhaust gases flexi pipe (6.1.2 (a)) | 1 |
| Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b)) | 1 |
| Offside Rear Inner Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting Sill (6.2.2 (d) (i)) | 1 |
| Offside Front Outer Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Front Outer Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting (6.2.2 (d) (i)) | 1 |
| Offside Rear Inner Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting (6.2.2 (d) (i)) | 1 |
| Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b)) | 1 |
| Rear Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Brakes imbalanced across an axle | 1 |
| Exhaust system insecure (6.1.2 (a)) | 1 |
| Speedometer cannot be illuminated (7.8 (c) (ii)) | 1 |
| Registration plate lamp issues | 1 |
| Anti-lock braking system warning lamp indicates an ABS fault | 1 |
| Speedometer clearly inoperative (7.8 (b) (ii)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Rear Road wheel fixing missing (5.2.1 (a) (i)) | 1 |
| Offside Rear Direction indicator incorrect colour (4.4.3 (a)) | 1 |
| Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Offside Rear Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
| Offside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |
| Nearside Rear Stop lamp(s) with a multiple light source more than 1/2 not functioning (4.3.1 (a) (ii)) | 1 |
| Offside Front Sub-frame corroded and seriously weakened Subframe corroded/holed at front mounting (5.3.3 (b) (i)) | 1 |
| Nearside Rear Brake prescribed area is excessively corroded Brake load valve mounting area corroded/holed (1.1.21 (e) (i)) | 1 |
| Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength Leaf spring mounting area (front) corroded/holed. Outer sill. (5.3.6 (a) (i)) | 1 |
| Offside Rear Rear fog lamp lens defective such that emitted light is adversely affected Lens defective white light shown to rear. (4.5.1 (b) (ii)) | 1 |
| Nearside Front Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Lower arm mounting area on subframe corroded/holed (front) (5.3.6 (a) (i)) | 1 |
| Offside Front Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Lower arm mounting area on subframe corroded/holed (front) (5.3.6 (a) (i)) | 1 |
| Nearside Front Sub-frame corroded and seriously weakened Subframe corroded/holed at mounting area (front) (5.3.3 (b) (i)) | 1 |
| Offside Front Sub-frame corroded and seriously weakened Subframe corroded/holed at mounting area (front) (5.3.3 (b) (i)) | 1 |
| Nearside Rear Brake prescribed area is excessively corroded Load valve mounting area corroded/holed (1.1.21 (e) (i)) | 1 |
| Offside Rear Shock absorbers has a serious fluid leak | 1 |
| Nearside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Shock absorber upper mount area corroded/holed. (5.3.6 (a) (i)) | 1 |
| Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength Leaf spring mounting area corroded/holed. (5.3.6 (a) (i)) | 1 |
| Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner sill corroded/holed. (6.1.1 (c) (i)) | 1 |
| Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill, within 30cm of suspension component (6.1.1 (c) (i)) | 1 |