| Most common failures | No# failures |
|---|
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 4 |
| Registration plate lamp issues | 4 |
| Offside Side repeater not working |1.4.A.2c| | 3 |
| Headlamp aim out of alignment | 2 |
| Brakes imbalanced across an axle | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Position lamp switch does not operate in accordance with the requirements (4.2.2 (a)) | 1 |
| Battery insecure and likely to cause a short circuit (4.13 (a) (ii)) | 1 |
| Exhaust system insecure (6.1.2 (a)) | 1 |
| Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing (6.1.1 (c) (i)) | 1 |
| Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Nearside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
| Offside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
| Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced under sill (6.1.1 (c) (i)) | 1 |
| Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Offside Side repeater not working (4.4.1 (a) (ii)) | 1 |
| Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) | 1 |
| Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) | 1 |
| Offside Front Service brake excessively fluctuating (1.2.1 (e)) | 1 |
| Offside Front Service brake lagging in operation (1.2.1 (d)) | 1 |
| Registration plate issues | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Front Side repeater not working |1.4.A.2c| | 1 |
| Offside Brake pipe inadequately clipped |3.6.B.1| | 1 |
| Offside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Offside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Nearside Headlamp insecure |1.7.3| | 1 |
| Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing (6.1.1 (c) (i)) | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
| Nearside Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
| Offside Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
| Centre Stop lamp has less than 50% of the light sources illuminating |1.2.1b| | 1 |
| Nearside Side repeater not working |1.4.A.2c| | 1 |
| Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Front brake application uneven | 1 |
| front brakes release unevenly |3.7.B.4| | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Headlamp not working on main beam |1.7.5a| | 1 |
| Exhaust system not adequately supported |7.1.1| | 1 |
| Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Headlamp aim unable to be tested (4.1.2 (b)) | 1 |
| Nearside Rear Rear wheel bearing has excessive play |2.6.2| | 1 |
| Nearside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength box section above leaf spring x2 (5.3.6 (a) (i)) | 1 |
| Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
| Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i)) | 1 |
| Battery insecure and likely to fall from carrier (4.13 (a) (ii)) | 1 |
| Central Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Rear brake binding | 1 |
| Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outer sill where marked with chalk |6.1.B.2| | 1 |
| Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outer and inner sill where marked with chalk |6.1.B.2| | 1 |
| Offside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
| Brake hose excessively deteriorated | 1 |
| Nearside Rear wheel bearing has excessive play |2.6.2| | 1 |
| Offside Rear wheel bearing has excessive play |2.6.2| | 1 |
| Nearside Rear Leaf spring has excessive wear in a shackle pin and/or bush |2.4.B.2| | 1 |
| Offside Rear Leaf spring has excessive wear in a shackle pin and/or bush |2.4.B.2| | 1 |