Most common failures | No# failures |
---|
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h)) | 357 |
Headlamp aim out of alignment | 318 |
Windscreen wiper does not clear the windscreen effectively | 185 |
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 120 |
Brake pipe excessively corroded | 98 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 74 |
Anti-lock braking system warning lamp indicates an ABS fault | 56 |
Offside Rear Direction indicator incorrect colour (4.4.3 (a)) | 44 |
Brake hose excessively deteriorated | 38 |
Registration plate issues | 37 |
Front brake disc in such a condition that it is seriously weakened | 36 |
Offside Front Coil spring fractured or broken (5.3.1 (b) (i)) | 36 |
Registration plate lamp issues | 35 |
Windscreen washer not working | 33 |
Nearside Rear Direction indicator incorrect colour (4.4.3 (a)) | 32 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 32 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 30 |
Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 28 |
Offside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 27 |
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 26 |
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 26 |
Offside Stop lamp(s) not working (4.3.1 (a) (ii)) | 25 |
Oil leaking excessively from engine (8.4.1 (a) (i)) | 24 |
Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 23 |
Nearside Front Coil spring fractured or broken (5.3.1 (b) (i)) | 23 |
Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 22 |
Nearside Stop lamp(s) not working (4.3.1 (a) (ii)) | 22 |
Brakes imbalanced across an axle | 21 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 21 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i)) | 20 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i)) | 20 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 18 |
Offside Rear Coil spring fractured or broken (5.3.1 (b) (i)) | 18 |
Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 17 |
Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 16 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 16 |
Offside Rear Direction indicator incorrect colour |1.4.A.2f| | 14 |
Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 14 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 14 |
Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 14 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 13 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 13 |
Offside Rear Parking brake inoperative on one side (1.4.1 (a)) | 13 |
Nearside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i)) | 13 |
Rear Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 13 |
Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 13 |
Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 13 |
Nearside Rear Direction indicator incorrect colour |1.4.A.2f| | 12 |
Parking brake: efficiency below requirements |3.7.B.7| | 12 |
Rear brake disc in such a condition that it is seriously weakened | 12 |
Emissions not tested (8.2.1.2 (d)) | 12 |
Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 12 |
Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 12 |
Nearside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i)) | 12 |
Offside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i)) | 12 |
Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b)) | 12 |
Central Rear Seat belt not functioning as intended (7.1.2 (c)) | 11 |
Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g)) | 11 |
Bonnet cannot be secured in the closed position (3.1 (b) (i)) | 11 |
Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 11 |
Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i)) | 11 |
Brake performance not tested (1.2.1 (g)) | 11 |
Rear parking brake recording little or no effort | 10 |
Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i)) | 10 |
Offside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i)) | 10 |
Offside Rear Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i)) | 10 |
Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 10 |
Nearside Parking brake inoperative on one side (1.4.1 (a)) | 10 |
Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 9 |
Nearside Rear Road wheel fixing missing (5.2.1 (a) (i)) | 9 |
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 9 |
Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 9 |
Supplementary restraint system warning lamp indicates a fault (7.1.6 (a)) | 9 |
Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 9 |
Offside Rear Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 9 |
Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i)) | 9 |
Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b)) | 9 |
Offside Headlamp not working on dipped beam |1.7.5a| | 8 |
Engine MIL inoperative or indicates a malfunction |8.2.1.2 |h|| | 8 |
Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 8 |
Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 8 |
Nearside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 8 |
Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 8 |
Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 8 |
Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturers specified limits (8.2.1.2 (a)) | 8 |
Rear Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 8 |
Nearside Headlamp not working on main beam (4.1.1 (a) (ii)) | 8 |
Nearside Rear Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 8 |
Nearside Headlamp levelling device inoperative (4.1.5 (a)) | 8 |
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 8 |
Offside Stop lamp not working |1.2.1b| | 7 |
Offside Front coil spring broken |2.4.C.1a| | 7 |
Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i)) | 7 |
Offside Side repeater not working (4.4.1 (a) (ii)) | 7 |
Offside Rear Service brake excessively binding (1.2.1 (f)) | 7 |
Exhaust carbon monoxide content at idle exceeds manufacturers specified limits (8.2.1.2 (b)) | 7 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 7 |
Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 7 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 7 |
Offside Front Road wheel fixing missing (5.2.1 (a) (i)) | 7 |
Nearside Rear Shock absorbers has an excessively worn bush (5.3.2 (c)) | 7 |
Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 7 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 7 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 6 |
Offside Rear Shock absorber has an excessively worn bush |2.7.4| | 6 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 6 |
Stop lamp remains on when the brakes are released | 6 |
Nearside Stop lamp not working |1.2.1b| | 6 |
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 6 |
Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i)) | 6 |
Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i)) | 6 |
Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 6 |
Offside Parking brake inoperative on one side (1.4.1 (a)) | 6 |
Offside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i)) | 6 |