| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 4 |
| Windscreen wiper does not clear the windscreen effectively | 3 |
| Windscreen has damage | 2 |
| Offside Front Headlamp not working on dipped beam |1.7.5a| | 2 |
| Nearside Rear Stop lamp not working |1.2.1b| | 2 |
| Offside Rear Suspension spring mounting prescribed area is fractured |2.4.A.3| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Front brake application uneven | 1 |
| Rear Suspension spring mounting prescribed area is fractured |2.4.A.3| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded INNER WHEEL ARCH HOLED & CORRODED |2.4.A.3| | 1 |
| Rear Stop lamp not working O/S,N/S |1.2.1b| | 1 |
| Registration plate lamp issues | 1 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
| Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 1 |
| Rear Stop lamp not working |1.2.1b| | 1 |
| Registration plate issues | 1 |
| Nearside Rear Body has a projection caused by damage |6.1.C.1| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Rear Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Offside Rear Upper Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front Lower Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Supplementary Restraint System warning lamp indicates a fault |5.4.2| | 1 |
| Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Rear Shock absorber casing corroded externally so the unit does not function |2.7.2a| | 1 |
| Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Rear fog lamp not working |1.3.2b| | 1 |
| Rear Brake load sensing valve linkage seized |3.6.E.3| | 1 |
| Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Vehicle structure has an inadequate repair, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Vehicle structure is damaged, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front Macpherson strut upper support bearing is rough in operation |2.5.B.1b| | 1 |
| Offside Front Brake hose twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |
| Brake hose damaged | 1 |
| Brake load sensing valve linkage seized |3.6.E.3| | 1 |
| Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 1 |
| Emissions not tested |7.0| | 1 |
| Nearside Rear Suspension spring mounting prescribed area is fractured |2.4.A.3| | 1 |
| Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
| Rear Exhaust system not adequately supported |7.1.1| | 1 |
| Driver`s door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
| Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Front coil spring incomplete |2.4.C.1a| | 1 |
| Offside Front coil spring incomplete |2.4.C.1a| | 1 |
| Nearside Front front brake juddering severely |3.7.A.2b| | 1 |
| Offside Front front brake juddering severely |3.7.A.2b| | 1 |
| Brakes imbalanced across an axle | 1 |