Most common failures | No# failures |
---|
Headlamp aim out of alignment | 7 |
Registration plate lamp issues | 5 |
Brakes imbalanced across an axle | 5 |
Brake hose excessively deteriorated | 4 |
Exhaust system not adequately supported |7.1.1| | 3 |
Service brake: efficiency below requirements |3.7.B.7| | 3 |
Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 3 |
Offside Stop lamp not working |1.2.1b| | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Brake pipe excessively corroded | 3 |
Windscreen washer not working | 2 |
Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 2 |
Horn not working |1.6.2a| | 2 |
Rear Mechanical brake component has restricted free movement | 2 |
Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Nearside front brake binding |3.7.B.1| | 2 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 2 |
Rear brake binding | 2 |
Hazard warning switch faulty |1.4.B.1d| | 2 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 2 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 2 |
Offside Front front brake binding |3.7.B.1| | 2 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
Offside Side repeater not working |4.4.1 |a| |ii|| | 1 |
Offside Seat belt retracting mechanism defective |5.2.5b| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded inner sill area |2.4.A.3| | 1 |
Offside Stop lamp emits other than a steady red light |1.2.1e| | 1 |
Offside Rear position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Offside Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 1 |
Passenger`s seat cannot be secured in the upright position. |6.2.A.2| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded lower floor pan / inner wheel arch edge |2.4.A.3| | 1 |
Nearside Seat belt anchorage prescribed area is excessively corroded centre floor pan to inner sill edges holed & corroded |5.2.6| | 1 |
Offside Seat belt anchorage prescribed area is excessively corroded centre floor pan to inner sill edges holed & corroded |5.2.6| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded cross-member / inner valance holed & corroded |2.4.A.3| | 1 |
Exhaust has a major leak of exhaust gases Rear box holed & blowing |7.1.2| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Nearside Rear front brake binding |3.7.B.1| | 1 |
Nearside Rear Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Rear Rear fog lamp not working |1.3.2b| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Headlamp aim beam image kick up to the offside |1.8| | 1 |
Indicator tell tale inoperative |1.4.A.2a| | 1 |
Nearside Front Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
Brake pedal spongy |3.3.B.1b| | 1 |
Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Offside Rear Brake pipe inadequately supported |3.6.B.1| | 1 |
Offside Outer Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Outer Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Nearside Front Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Exhaust emissions carbon monoxide content excessive 5.56% (8.2.1.2 (b)) | 1 |
Exhaust emissions hydrocarbon content excessive 2550ppm (8.2.1.2 (b)) | 1 |
Offside Rear fog lamp missing (4.5.1 (a) (ii)) | 1 |
Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
Nearside Steering rack deformed and unserviceable |2.2.C.1d| | 1 |
Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Outer Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Outer Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Offside Rear Shock absorber casing damaged externally so the unit does not function |2.7.2a| | 1 |
Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Nearside Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Offside Front Direction indicator not working |4.4.1 |a| |ii|| | 1 |
Offside Rear Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill / wheel arch (5.3.6 (a) (i)) | 1 |
Offside Front Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill corroded by jacking point (6.2.2 (d) (i)) | 1 |
Offside Rear All direction indicators not working (4.4.1 (a) (ii)) | 1 |
Offside Front Steering linkage ball joint has excessive play ball joint inside steering rack(steering arm excessive movement ) (2.1.3 (b) (i)) | 1 |
Battery insecure |1.9.1| | 1 |
Front Windscreen wiper blade deteriorated |8.2.2| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Oil leaking excessively from engine (8.4.1 (a) (i)) | 1 |
Offside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
Brake hose damaged | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Exhaust mounting missing |7.1.1b| | 1 |
Offside Rear Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Offside Front Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Offside Front Obligatory mirror missing |8.1.1| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Driver`s door does not latch securely closed |6.2.B.1a| | 1 |
Offside Rear Stop lamp not working |1.2.1b| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
Offside Front Direction indicator incomplete |1.5.A1b| | 1 |
Nearside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Outer Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Front brake application uneven | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
front brakes release unevenly |3.7.B.4| | 1 |
Offside Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Fuel cap/sealing device sealing washer missing |7.2.4c| | 1 |
Steering system fouling |2.2.D.2a| | 1 |
Steering system excessively rough |2.2.D.1| | 1 |
Nearside Front Brake pipe inadequately clipped |3.6.B.1| | 1 |
Brake pipe inadequately clipped |3.6.B.1| | 1 |
Brake pipe inadequately supported |3.6.B.1| | 1 |
Nearside Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
Nearside Passenger`s seat cannot be secured in the upright position. |6.2.A.2| | 1 |
Nearside Front Suspension arm insecure |2.4.G.1| | 1 |
Nearside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Hazard warning tell tale not working correctly |1.4.B.1e| | 1 |