| Most common failures | No# failures |
|---|
| Brake pipe excessively corroded | 11 |
| Windscreen wiper does not clear the windscreen effectively | 10 |
| Headlamp aim out of alignment | 9 |
| Registration plate issues | 5 |
| Horn not working |1.6.2a| | 5 |
| Brakes imbalanced across an axle | 3 |
| Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 2 |
| Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 2 |
| Front brake application uneven | 2 |
| Brake performance not tested (1.2.1 (g)) | 1 |
| Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone A Phone holder super glued to windscreen (8.3.1e) | 1 |
| Nearside front brake binding (3.7.B.1) | 1 |
| Offside front brake binding (3.7.B.1) | 1 |
| Exhaust emits an excessive level of metered smoke for a turbo charged engine |7.4.B.3b| | 1 |
| Front Service brake excessively binding both sides (1.2.1 (f)) | 1 |
| Offside Upper Front position lamp|s| not working |1.1.A.3b| | 1 |
| Rear Upper Outline marker lamp does not illuminate simultaneously with the position lamps Both Sides (4.2.2 (a)) | 1 |
| Offside Front Upper Outline marker lamp does not illuminate simultaneously with the position lamps (4.2.2 (a)) | 1 |
| Nearside Front Upper Outline marker lamp does not illuminate simultaneously with the position lamps (4.2.2 (a)) | 1 |
| Offside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Brake pipe connection leaking on a hydraulic braking system Central above sub frame to N/S/F (1.1.11 (b) (ii)) | 1 |
| Nearside Front Upper Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Windscreen washer not working | 1 |
| Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength Inner wheel arch (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area fractured significantly reducing structural strength Step area in a wheel arch in a seal outer seal (5.3.6 (a) (i)) | 1 |
| Offside Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Registration plate lamp issues | 1 |
| Nearside Rear Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2) | 1 |
| Offside Front Coil spring not correctly located (2.4.C.2) | 1 |
| Nearside front brake binding |3.7.B.1| | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i)) | 1 |
| Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Main beam tell-tale not working (4.9.1 (a) (ii)) | 1 |
| Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Horn not working (7.7 (a) (ii)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Subframe mounting (5.3.6 (a) (i)) | 1 |
| Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 1 |
| Horn not loud enough to be heard by another road user |1.6.2b| | 1 |
| Nearside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
| Rear brake binding | 1 |
| Nearside Front Braking system leaking |3.6.A.1| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Power steering pipe|s| or hose|s| leaking |2.3.3b| | 1 |
| Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced front cross member (6.1.1 (c) (i)) | 1 |
| Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting o/s/f chassis leg (6.2.2 (d) (i)) | 1 |
| Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner wing (6.2.2 (d) (i)) | 1 |
| Exhaust has a major leak of exhaust gases silencer has large hole in it (6.1.2 (a)) | 1 |
| Emissions unable to be completed due to hole in exhaust (8.2.2.2 (e)) | 1 |
| Nearside Side repeater not working |1.4.A.2c| | 1 |
| Rear Brake hose bulging under pressure |3.6.B.3| | 1 |
| Centre Stop lamp not working |1.2.1b| | 1 |
| Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
| Nearside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) | 1 |
| Nearside Front Wheel bearing has excessive play |5.1.3 |a| |i|| | 1 |
| Offside Outline marker lamp not working |4.2.1 |a|| | 1 |
| Nearside Front Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced wheel arch |6.1.1 |c| |i|| | 1 |
| Offside Front Upper Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wheel arch |6.1.1 |c| |i|| | 1 |
| Offside Front Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced wheel arch |6.1.1 |c| |i|| | 1 |
| Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Centre Exhaust system not adequately supported |7.1.1| | 1 |
| Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i)) | 1 |
| Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Chassis (7.1.1 (a) (i)) | 1 |
| Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Wheel arch (7.1.1 (a) (i)) | 1 |
| Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Horn sound not in accordance with requirements (7.7 (c)) | 1 |
| Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Stop lamp excessively damaged so that it is not visible from a reasonable distance |1.2.1d| | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings jacking point |6.1.B.2| | 1 |
| Rear Exhaust system not adequately supported |7.1.1| | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength mac strut turret (5.3.6 (a) (i)) | 1 |
| Offside Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a)) | 1 |
| Nearside Front Front constant velocity joint gaiter split |2.5.C.1a| | 1 |