| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 4 |
| Windscreen wiper does not clear the windscreen effectively | 4 |
| Brake hose excessively deteriorated | 3 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 2 |
| Nearside Headlamp not working on main beam |1.7.5a| | 2 |
| Offside Rear fog lamp not working |1.3.2b| | 2 |
| Rear Rear fog lamp not working |1.3.2b| | 2 |
| Rear brake binding | 2 |
| Offside Rear Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Nearside Rear Direction indicator not working |1.4.A.2c| | 1 |
| Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Windscreen wiper blade missing |8.2.2| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Exhaust emissions carbon monoxide content excessive (7.3.B.1a) | 1 |
| Nearside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2) | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3) | 1 |
| Nearside rear brake recording little or no effort (3.7.B.5a) | 1 |
| Offside Rear fog lamp not working (1.3.2b) | 1 |
| Drivers seat fore and aft adjustment mechanism not functioning as intended. (6.2.A.3) | 1 |
| Drivers seat insecure (6.2.A.1) | 1 |
| Nearside Front Body has a sharp edge caused by corrosion (6.1.C.1) | 1 |
| Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1) | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3) | 1 |
| Brakes imbalanced across an axle | 1 |
| Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3) | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3) | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3) | 1 |
| Nearside Front Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) | 1 |
| Rear fog lamp not working (1.3.2b) | 1 |
| Nearside Headlamp not working on main beam (1.7.5a) | 1 |
| Offside Front Upper Suspension arm has excessive play in a pin/bush outer (2.4.G.2) | 1 |
| Offside Front wheel bearing rough when rotated (2.5.A.2) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength x2 (5.3.6 (a) (i)) | 1 |
| Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
| Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Offside Front Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) | 1 |
| Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) | 1 |
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside front brake binding |3.7.B.1| | 1 |
| Offside front brake binding |3.7.B.1| | 1 |
| Registration plate lamp issues | 1 |
| Nearside Front Direction indicator not working |1.4.A.2c| | 1 |
| Steering system has excessive free play detected at the steering wheel |steering box fitted| |2.2.A.1a| | 1 |
| Steering pivot point has excessive play |2.2.B.1g| | 1 |
| Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
| Anti-roll bar attachment bracket/mounting insecure |2.4.G.1| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |