Most common failures | No# failures |
---|
Headlamp aim out of alignment | 19 |
Rear reflector on motorcycle missing |1.4.1| | 12 |
Registration plate issues | 10 |
Rear wheel bearings have excessive free play |2.4.A.2c| | 6 |
Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 4 |
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 4 |
Rear Rear reflector on motorcycle missing |1.4.1| | 4 |
Rear suspension bush has excessive free play |2.4.A2a|i|| | 4 |
Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 4 |
Drive chain worn to excess |6.2.1e| | 3 |
Rear Position lamp not working (4.2.1 (a)) | 3 |
Fuel system component leaking |7.2.1a| | 3 |
Front wheel bearings have excessive free play |2.3.5b| | 3 |
Rear wheel spindle securing nut locking device missing |2.4.A.2b| | 3 |
Drive chain excessively tight |6.2.1d| | 2 |
Rear mono-shock pivot excessively worn |2.4.B.4| | 2 |
Nearside Rear Direction indicators not working |1.5.1c| | 2 |
Registration plate lamp issues | 2 |
Front Brake fluid reservoir fluid level dangerously low |3.2.B1d| | 2 |
Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 2 |
Handlebar handgrip not secure to handlebars. |2.1.1c| | 2 |
Rear Roller brake test indicates a binding brake |3.3.A1a| | 2 |
Locking device|s| not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 2 |
Front Roller brake test indicates a binding brake |3.3.A1a| | 2 |
Drive chain excessively loose |6.2.1d| | 2 |
Rear Rear wheel spindle securing nut locking device missing |2.4.A.2b| | 2 |
Rear reflector missing (4.8.2 (a) (ii)) | 2 |
Centre Rear Rear reflector on motorcycle missing |1.4.1| | 2 |
Front Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 2 |
Front Floor brake test indicates a binding brake |3.3.C2c| | 1 |
Front Brake disc|s| cracked |3.2.A1g| | 1 |
Centre Rear reflector on motorcycle missing |1.4.1| | 1 |
Rear suspension bearing has excessive free play |2.4.A2a|i|| | 1 |
Lower Rear suspension bush has excessive free play |2.4.A2a|i|| | 1 |
Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
Horn not working |1.7.3a| | 1 |
Rear suspension movement is excessively stiff |2.4.A.3b| | 1 |
Rear Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 1 |
Rear Suspension component pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
Steering headbearing has excessive wear or free play (2.2.2 (f) (i)) | 1 |
Rear Brake disc|s| cracked |3.2.A1g| | 1 |
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
Rear Lower Suspension component pin or bush excessively worn rear suspension rocker arm bearing worn to exess (5.3.4 (a) (i)) | 1 |
Direction indicator missing |1.5.1a| | 1 |
Rear Stop lamp not working |4.3.1 |a| |ii|| | 1 |
Brake component has an inadequate repair |3.1.5| | 1 |
Nearside Handlebar handgrip not secure to handlebars. |2.1.1c| | 1 |
Horn sounds harsh or grating |1.7.3c| | 1 |
Nearside Rear Direction indicator not working |1.5.1c| | 1 |
Nearside Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Wheel alignment incorrect which adversely affects the steering |2.5.1| | 1 |
Rear Drive chain sprocket worn to excess |6.2.1e| | 1 |
Inner Rear Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 1 |
Front Drive chain sprocket worn to excess |6.2.1e| | 1 |
Front Brake lever attachment screws loose |3.1.2b| | 1 |
Front wheel bearings are excessively rough |2.3.5b| | 1 |
Front Brake fluid significantly below minimum mark |1.1.10 |d| |ii|| | 1 |
Front Brake lever has insufficient reserve travel |1.1.2 |a|| | 1 |
Nearside Front Direction indicators not working |1.5.1c| | 1 |
Nearside Front Direction indicator insecure |1.5.3b| | 1 |
Front position lamp damaged and function impaired |1.1.1b| | 1 |
Rear Lower Rear mono-shock pivot excessively worn |2.4.B.4| | 1 |
Rear Lower Rear suspension bearing has excessive free play |2.4.A2a|i|| | 1 |
Suspension component pin or bush excessively worn |5.3.4 |a| |i|| | 1 |
Shock absorber has negligible damping effect |5.3.2 |b|| | 1 |
Steering headbearing has excessive free play |2.2.2| | 1 |
An item not tested |Manual| | 1 |
Rear Brake component damaged and seriously reduced in strength |3.2.A1| | 1 |
Roller brake test No brake control achieves an efficiency of 30%. |3.3.A2a| | 1 |
Roller brake test Neither brake control achieves an efficiency of 25% |3.3.A2b| | 1 |
Fuel hose leaking |7.2.1a| | 1 |
Rear shock absorber seal failed and leaking oil |2.4.A.1c| | 1 |
Offside Rear Direction indicator not working |1.5.1c| | 1 |
Rear Wheel fixing missing (single fixing) Locking device missing (5.2.1 (a) (ii)) | 1 |
Front Brake caliper|s| securing bolt|s| loose |3.2.A1j| | 1 |
Front position lamp does not illuminate immediately when switched on |1.1.3a| | 1 |
Rear Rear suspension bush has excessive free play |2.4.A2a|i|| | 1 |
Rear Rear mono-shock pivot excessively worn |2.4.B.4| | 1 |
Stop lamp damaged and function impaired |1.3.3a| | 1 |
Steering movement excessively `notchy` with the weight on the lower bearing |2.2.1a| | 1 |
Lower Rear suspension bearing has excessive free play |2.4.A2a|i|| | 1 |
Front Brake hose leaking fluid |3.2.B4| | 1 |
Suspension arm pin or bush excessively worn suspension linkage bearings |5.3.4 |a| |i|| | 1 |
Offside Rear Direction indicators not working |1.5.1c| | 1 |
Exhaust mounting missing |7.1.1c| | 1 |
Throttle operating incorrectly (6.2.7 (a) (i)) | 1 |
Rear position lamp insecure |1.1.1c| | 1 |
Rear Rear reflector missing |4.8.2 |a| |ii|| | 1 |
Rear Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 1 |
Front Horn not working |1.7.3a| | 1 |
Horn not working |7.7 |a| |ii|| | 1 |
Rear Roller brake test indicates brake effort rise disproportional to brake lever or pedal effort |3.3.A1c| | 1 |
Front Front suspension fouling which affects the movement of the front suspension. |2.3.6a| | 1 |
Dipswitch does not extinquish main beam/s, leaving at least 1 dipped beam headlamp |1.2.2b|i|| | 1 |
Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a)) | 1 |
Fuel system component leaking carb |7.2.1a| | 1 |
Rear Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) | 1 |
Brake hose excessively deteriorated | 1 |
Direction indicators not working |1.5.1c| | 1 |
Headlamp aim not tested (4.1.2 (b)) | 1 |
Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Rear Brake fluid reservoir fluid level dangerously low |3.2.B1d| | 1 |
Centre Rear Rear shock absorber seal failed and leaking oil |2.4.A.1c| | 1 |
Rear Rear wheel bearings have excessive free play |2.4.A.2c| | 1 |
Headlamp aim beam image kick up to the offside |1.6| | 1 |
Nearside Handlebar mounting clamp bolt loose |2.1.1a| | 1 |