| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 3 |
| Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 2 |
| Rear reflector on motorcycle missing |1.4.1| | 2 |
| Nearside Front Shock absorber has a serious fluid leak |5.3.2 |b|| | 2 |
| Drive chain excessively loose |6.2.1d| | 2 |
| Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 2 |
| Drive chain excessively loose (6.1.7 (c) (i)) | 2 |
| Registration plate issues | 2 |
| Rear Position lamp not working (4.2.1 (a)) | 2 |
| Offside Front Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
| Rear Rear wheel bearings have excessive free play |2.4.A.2c| | 1 |
| Nearside Rear wheel bearings are excessively rough |2.4.A.2c| | 1 |
| Nearside Rear Footrest insecure |6.2.1a| | 1 |
| Rear Position lamp not working |4.2.1 |a|| | 1 |
| Offside Front Direction indicators not working |1.5.1c| | 1 |
| Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
| Nearside Front Brake disc|s| is excessively distorted |3.2.A1m| | 1 |
| Headlamp aim beam image kick up to the offside |1.6| | 1 |
| Front Brake performance not tested |3.3| | 1 |
| Floor brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.C1b| | 1 |
| Rear Brake fluid reservoir fluid level dangerously low |3.2.B1d| | 1 |
| Stop lamp not working |4.3.1 |a| |ii|| | 1 |
| Drive chain excessively tight |6.2.1d| | 1 |
| Nearside Front Direction indicator incorrect colour |1.5.1b| | 1 |
| Front Brake excessively binding (1.2.1 (f)) | 1 |
| Rear Brake excessively binding (1.2.1 (f)) | 1 |
| Front Brake lever has insufficient reserve travel (1.1.2 (a)) | 1 |
| Offside Rear Lower Stop lamp switch with a delay in operation Switch adjusted (4.3.2 (a) (ii)) | 1 |
| Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
| Rear position lamp adversely affected by the operation of another lamp |1.1.3b| | 1 |
| Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition (8.1.1 (a)) | 1 |
| Rear Brake indicates excessive fluctuation of brake effort (1.2.1 (e)) | 1 |
| Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
| Nearside Rear Direction indicator not working |4.4.1 |a| |ii|| | 1 |
| Offside Rear Exhaust system insecure |6.1.2 |a|| | 1 |
| Steering headbearing has excessive wear or free play (2.2.2 (f) (i)) | 1 |
| Rear Lower Rear mono-shock insecure |2.4.B.4| | 1 |
| Rear Lower Rear shock absorber insecurely mounted |2.4.A.3b| | 1 |
| Front position lamp incorrect colour |1.1.2a| | 1 |
| Front Stop lamp remains on when the brake is released |1.3.1e| | 1 |
| Nearside Handlebar grip insecure to handlebar grip loose on bar |2.2.1 |d| |ii|| | 1 |
| Rear All position lamps light intensity significantly reduced one tail light inoperative |4.2.3 |a| |ii|| | 1 |
| Front Direction indicators not working |1.5.1c| | 1 |
| Rear Stop lamp remains on when the brake is released |1.3.1e| | 1 |
| Exhaust mounting does not fully support the exhaust system |7.1.1.c| | 1 |
| Offside Front Shock absorber has a serious fluid leak (5.3.2 (b)) | 1 |
| Rear Stop lamp missing |1.3.3a| | 1 |
| Rear Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) | 1 |
| Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Centre Front Roller brake test indicates a binding brake |3.3.A1a| | 1 |
| Nearside Outer Brake disc|s| is excessively distorted |3.2.A1m| | 1 |
| Offside Rear Brake pedal has inadequate reserve travel |3.1.3b| | 1 |
| Exhaust has a major leak of exhaust gases down pipes to collector |6.1.2 |a|| | 1 |
| Stop lamp not working from front brake |4.3.1 |a| |ii|| | 1 |
| Rear Brake disc significantly and obviously worn (1.1.14 (a) (i)) | 1 |
| Rear Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
| Exhaust is leaking and excessively noisey |7.1.1b| | 1 |