Most common failures | No# failures |
---|
Headlamp aim out of alignment | 17 |
Rear reflector on motorcycle missing |1.4.1| | 15 |
Horn not working |1.7.3a| | 10 |
Nearside Front shock absorber seal failed and leaking oil |2.3.3| | 9 |
Offside Front shock absorber seal failed and leaking oil |2.3.3| | 8 |
Drive chain excessively loose |6.2.1d| | 7 |
Registration plate issues | 7 |
Front Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 6 |
Front Roller brake test indicates a binding brake |3.3.A1a| | 5 |
Exhaust is leaking and excessively noisey |7.1.1b| | 5 |
Rear Roller brake test indicates a binding brake |3.3.A1a| | 5 |
Rear Rear reflector on motorcycle missing |1.4.1| | 4 |
Brake locking device missing |3.2.A1e| | 4 |
Front Front shock absorber seal failed and leaking oil |2.3.3| | 4 |
Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 3 |
Exhaust mounting does not fully support the exhaust system |7.1.1.c| | 3 |
Offside Rear Footrest missing |6.2.1a| | 3 |
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 3 |
Rear Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 3 |
Headlamp aim beam image kick up to the offside |1.6| | 3 |
Front Hydraulic brake control feels spongy |3.1.4a| | 3 |
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 3 |
Rear suspension bush has excessive free play |2.4.A2a|i|| | 3 |
Drive chain worn to excess |6.2.1e| | 3 |
Front wheel bearings are excessively rough |2.3.5b| | 3 |
Offside Handlebar deformed |2.1.1b| | 2 |
Rear suspension movement is excessively stiff |2.4.A.3b| | 2 |
Nearside Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 2 |
Nearside Headlamp aim beam image kick up to the offside |1.6| | 2 |
Offside Headlamp aim beam image kick up to the offside |1.6| | 2 |
Front suspension has inadequate damping effect. |2.3.6c| | 2 |
Offside Front Front shock absorber seal failed and leaking oil |2.3.3| | 2 |
Front Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 2 |
Steering headbearing has excessive free play |2.2.2| | 2 |
Rear Floor brake test indicates a binding brake |3.3.C2c| | 2 |
Nearside Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 2 |
Nearside Rear Footrest missing |6.2.1a| | 2 |
Direction indicators not working |1.5.1c| | 2 |
Throttle has a significant change in engine speed whilst moving the steering from lock to lock |2.1.4| | 2 |
Nearside Front Front shock absorber seal failed and leaking oil |2.3.3| | 2 |
Steering control fouling between components which interferes with the free movement of the steering |2.1.2a| | 2 |
Roller brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.A2b| | 2 |
Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 2 |
Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition |7.1.2| | 2 |
Rear Drive chain sprocket worn to excess |6.2.1e| | 2 |
Front Horn not working |1.7.3a| | 2 |
Drive chain excessively tight |6.2.1d| | 2 |
Floor brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.C1b| | 2 |
Front Steering lock stop maladjusted |2.1.3| | 1 |
Rear Brake disc|s| cracked |3.2.A1g| | 1 |
Centre Rear Rear reflector on motorcycle missing |1.4.1| | 1 |
Front suspension has excessive stiffness in the suspension movement. |2.3.6b| | 1 |
Brake lever has inadequate reserve travel |3.1.3b| | 1 |
Offside Front Brake hose leaking fluid |3.2.B4| | 1 |
Offside Front Front suspension assembly component missing |2.3.1| | 1 |
Offside Steering lock stop maladjusted |2.1.3| | 1 |
Front Front suspension has inadequate damping effect. |2.3.6c| | 1 |
Front Direction indicators flashing less than 60 times a minute |1.5.1c| | 1 |
Rear Direction indicators flashing less than 60 times a minute |1.5.1c| | 1 |
Front Direction indicator affected by the operation of another lamp |1.5.1c| | 1 |
Rear Direction indicator affected by the operation of another lamp |1.5.1c| | 1 |
Nearside Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 1 |
All position lamps adversely affected by the operation of another lamp |1.1.3b| | 1 |
Offside Brake lever is so short and the brake cannot be readily applied |3.1.3c| | 1 |
Nearside Handlebar deformed |2.1.1b| | 1 |
Offside Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k| | 1 |
Nearside Steering control has Insufficient clearance at full lock affecting the riders grasp of handlebars |2.1.2b| | 1 |
Front Roller brake test indicates a severely grabbing brake |3.3.A1b| | 1 |
Front Wheel has an excessively distorted bead rim. |4.2.2| | 1 |
Nearside Footrest insecure |6.2.1a| | 1 |
Rear Brake component has restricted free movement and operation is likely to be impeded caliper fouling rear wheel |3.2.A1h| | 1 |
Front Headlamp insecure |1.2.3b| | 1 |
Nearside Front Direction indicators not working |1.5.1c| | 1 |
Nearside Rear Direction indicators flashing less than 60 times a minute |1.5.1c| | 1 |
Offside Front An item not tested |Manual| | 1 |
Nearside Front Direction indicator insecure |1.5.3b| | 1 |
Offside Handlebar handgrip not secure to handlebars. |2.1.1c| | 1 |
Riders seat insecure |6.2.1a| | 1 |
Rear Brake caliper|s| securing bolt|s| missing |3.2.A1j| | 1 |
Rear Rear shock absorber seal failed and leaking oil |2.4.A.1c| | 1 |
Rear Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 1 |
Front Headlamp main beam affected by the operation of another lamp |1.2.2c| | 1 |
Front Fairings insecure and likely to impede the steering |2.1.2e| | 1 |
Fuel cap sealing washer deteriorated |7.2.2c| | 1 |
Front Brake lever attachment screws missing |3.1.2b| | 1 |
Rear Brake lever mounting insecure |3.1.2a| | 1 |
Exhaust markings indicating not for road use or similar wording |7.1.4| | 1 |
Fuel pipe leaking |7.2.1a| | 1 |
Offside Front Brake disc|s| securing bolt|s| missing |3.2.A1g| | 1 |
Front Brake fluid reservoir fluid level dangerously low |3.2.B1d| | 1 |
Rear Exhaust mounting does not fully support the exhaust system |7.1.1.c| | 1 |
Rear Roller brake test indicates brake effort rise disproportional to brake lever or pedal effort |3.3.A1c| | 1 |
Wheel alignment incorrect which adversely affects the handling |2.5.1| | 1 |
Central Rear Lower Drive chain worn to excess chain and sprockets worn and not suitable for this vehicle |6.2.1e| | 1 |
Steering operation linkage fouling when handlebars turned from lock to lock (2.1.4 (a)) | 1 |
Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 1 |
Rear mono-shock pivot excessively worn |2.4.B.4| | 1 |
Front Brake lever insecure |3.1.2a| | 1 |
Centre Front Roller brake test indicates a binding brake |3.3.A1a| | 1 |
Nearside Front Handlebar deformed |2.1.1b| | 1 |
Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
Steering control has Insufficient clearance at full lock affecting the riders grasp of handlebars |2.1.2b| | 1 |
An item not tested |Manual| | 1 |
Offside Rear Rear wheel rotation likely to be impeded |6.2.1b| | 1 |
Nearside Exhaust excessively deteriorated |7.1.1a| | 1 |
Rear position lamp adversely affected by the operation of another lamp |1.1.3b| | 1 |
Front Steering headbearing has excessive free play |2.2.2| | 1 |
Front Front wheel bearings have excessive free play |2.3.5b| | 1 |
Offside Rear Locking devices not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 1 |
Rear Exhaust is leaking and excessively noisey |7.1.1b| | 1 |
Centre Front Lower Rear suspension bush has excessive free play |2.4.A2a|i|| | 1 |
Front Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
Brake lever cannot be released smoothly |3.1.3d| | 1 |
Rear wheel spindle securing nut locking device missing |2.4.A.2b| | 1 |
Front Front wheel bearings are excessively rough |2.3.5b| | 1 |
Front Brake disc|s| insecure |3.2.A1g| | 1 |
Steering control has Insufficient clearance at full lock affecting the riders operation of the controls |2.1.2b| | 1 |
Offside Front Brake locking device missing |3.2.A1e| | 1 |
Front Brake lever cannot be applied smoothly |3.1.3d| | 1 |
Offside Steering control has Insufficient clearance at full lock affecting the riders grasp of handlebars |2.1.2b| | 1 |
Rear Position lamp not working |4.2.1 |a|| | 1 |
Nearside Rear Footrest insecure point down |6.2.1a| | 1 |
Rear suspension fouling which affects the movement of the rear suspension |2.4.A.3a| | 1 |
Front Headlamp dipped beam flickers when tapped lightly by hand |1.2.2c| | 1 |
Centre Front Front suspension has inadequate damping effect. |2.3.6c| | 1 |
Nearside Front Direction indicator not working |1.5.1c| | 1 |
Centre Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
Nearside Rear Exhaust markings indicating not for road use or similar wording |7.1.4| | 1 |
Rear Brake locking device missing |3.2.A1e| | 1 |
Rear Floor brake test indicates a sticking brake |3.3.C2c| | 1 |
Offside Direction indicators not working |1.5.1c| | 1 |
Roller brake test The less effective brake control does not achieve an efficiency of 25% |1.2.2 |a| |i|| | 1 |
Headlamp aim not tested |1.6| | 1 |
Front Brake lever cannot be released smoothly |3.1.3d| | 1 |
Rear Locking devices not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 1 |
Rear reflector on motorcycle incorrectly positioned |1.4.2d| | 1 |