>

MOT History from tests of petrol YAMAHA FZ8s year 2010

Review the list of common YAMAHA FZ8 failures below or to perform a specific mot history check on your YAMAHA then use our popular KnowYourCar service

mot history
Pass percent:88.45%
(The average a petrol YAMAHA FZ8 year 2010 passes without issue)
Based on:805 MOT Tests
Most common failuresNo# failures
Headlamp aim out of alignment15
Registration plate issues13
Front Stop lamp does not illuminate immediately a brake applies |1.3.1a|5
Registration plate lamp issues5
Rear reflector on motorcycle missing |1.4.1|5
Stop lamp does not illuminate immediately a brake applies |1.3.1a|4
Rear reflector missing (4.8.2 (a) (ii))4
Rear reflector missing |4.8.2 |a| |ii||3
Drive chain excessively loose (6.1.7 (c) (i))3
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i||3
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a|2
Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))2
Drive chain worn to excess |6.2.1e|2
Drive chain excessively loose |6.2.1d|2
Headlamp aim projected beam image obviously incorrect (4.1.2 (c))2
Drive chain so loose it is likely to fail (6.1.7 (c) (ii))2
Suspension component pin or bush excessively worn Lower linkage (5.3.4 (a) (i))1
Front Stop lamp does not illuminate immediately a brake applies corroded connection |1.3.1a|1
Front wheel bearings are excessively rough |2.3.5b|1
Throttle operating incorrectly (6.2.7 (a) (i))1
Offside Front Throttle control functioning such that safe operation of the motorcycle is adversely affected Throttle sticking on. (6.2.7 (a) (ii))1
Offside Rear Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition (8.1.1 (a))1
Rear Valve stem seriously damaged (5.2.3 (j))1
Front Stop lamp not working |4.3.1 |a| |ii||1
Front Position lamp not working |4.2.1 |a||1
Rear Rear reflector missing |4.8.2 |a| |ii||1
Front Throttle operating incorrectly |6.2.1f|1
Stop lamp remains on when the brakes are released1
Front Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii))1
Front Brake disc|s| friction surface contaminated by oil or grease |3.2.A1k|1
Throttle operating incorrectly sticking open |adjusted| |6.2.1f|1
Exhaust mounting does not fully support the exhaust system |7.1.1.c|1
Front Stop lamp emits other than a steady red light flickers |1.3.1b|1
Rear position lamp adversely affected by the operation of another lamp indicators turn off rear position lamp when on |1.1.3b|1
Front position lamp incorrect colour |1.1.2a|1
Rear Rear reflector on motorcycle missing |1.4.1|1
Front Wheel bearing has excessive play (5.1.3 (a) (i))1
Headlamp aim not tested (4.1.2 (b))1
Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition |7.1.2|1
Nearside Front Footrest insecure |6.2.1a|1
Rear suspension bush has excessive free play |2.4.A2a|i||1
Throttle operating incorrectly sticking |6.2.7 |a| |i||1
Rear Stop lamp not working (4.3.1 (a) (ii))1
Offside Rear Locking device|s| not correctly fitted which may make the motor bicycle dangerous to ride drive chain adjustment bolt not secure |6.2.1h|1
Nearside Locking device|s| not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h|1
Front Wheel alignment incorrect which adversely affects the steering |2.5.1|1
Rear Exhaust mounting does not fully support the exhaust system |7.1.1.c|1
Offside Handlebar grip insecure to handlebar (2.2.1 (d) (ii))1
Offside Front Footrest insecure (6.2.12 (a))1
Riders seat insecure |6.2.1a|1
Rear Direction indicator obviously incorrectly positioned |4.4.3 |a||1
Rear Brake indicates excessive fluctuation of brake effort |1.2.1 |e||1
Rear Rear shock absorber has inadequate damping effect. |2.4.A.3b|1
Headlamp aim not tested vehicle failed to start, battery flat (4.1.2 (b))1
Rear Drive chain so loose it is likely to fail (6.1.7 (c) (ii))1
Headlamp insecure |1.2.3b|1
Rear Brake disc|s| excessively worn |3.2.A1l|1
Nearside Drive chain worn to excess |6.2.1e|1
Front Drive chain sprocket worn to excess |6.2.1e|1
Lower Rear mono-shock pivot excessively worn |2.4.B.4|1
Front Stop lamp not working (4.3.1 (a) (ii))1
Front wheel bearings have excessive free play |2.3.5b|1
Roller brake test indicates a binding brake |3.3.A1a|1
Rear Brake disc|s| cracked |3.2.A1g|1
Rear Wheel has an excessively distorted bead rim. |4.2.2|1
Offside Front Shock absorber has a serious fluid leak fork seal (5.3.2 (b))1
Offside Rear Direction indicator not working (4.4.1 (a) (ii))1
Nearside Rear Footrest missing (6.2.12 (a))1
Handlebar grip insecure to handlebar (2.2.1 (d) (ii))1
Riders seat insecure (6.2.5 (a) (ii))1
Headlamp not working on dipped beam |4.1.1 |a| |ii||1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy