Most common failures | No# failures |
---|
Headlamp aim out of alignment | 26 |
Rear reflector on motorcycle missing |1.4.1| | 9 |
Front Roller brake test indicates a binding brake |3.3.A1a| | 7 |
Offside Front shock absorber seal failed and leaking oil |2.3.3| | 6 |
Registration plate issues | 6 |
Drive chain excessively loose |6.2.1d| | 6 |
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 6 |
Nearside Front shock absorber seal failed and leaking oil |2.3.3| | 6 |
Exhaust is leaking and excessively noisey |7.1.1b| | 5 |
Rear wheel bearings have excessive free play |2.4.A.2c| | 5 |
Front wheel bearings are excessively rough |2.3.5b| | 4 |
Front position lamp does not illuminate immediately when switched on |1.1.3a| | 4 |
Front wheel bearings have excessive free play |2.3.5b| | 4 |
Horn not working |1.7.3a| | 4 |
Rear Rear reflector on motorcycle missing |1.4.1| | 3 |
Exhaust excessively deteriorated |7.1.1a| | 3 |
Rear Stop lamp not working (4.3.1 (a) (ii)) | 3 |
Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 3 |
Rear Roller brake test indicates a binding brake |3.3.A1a| | 3 |
Nearside Front Front shock absorber seal failed and leaking oil |2.3.3| | 3 |
Offside Front Front shock absorber seal failed and leaking oil |2.3.3| | 3 |
Roller brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.A2b| | 3 |
Drive chain sprocket carrier worn to excess |6.2.1e| | 2 |
Drive chain worn to excess |6.2.1e| | 2 |
Rear Drive chain sprocket worn to excess |6.2.1e| | 2 |
Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 2 |
Drive chain excessively tight |6.2.1d| | 2 |
Stop lamp remains on when the brakes are released | 2 |
Rear Rear wheel bearings have excessive free play |2.4.A.2c| | 2 |
Rear Brake excessively binding (1.2.1 (f)) | 2 |
Throttle operating incorrectly |6.2.1f| | 2 |
Front Floor brake test indicates a binding brake |3.3.C2c| | 2 |
Rear Floor brake test indicates a binding brake |3.3.C2c| | 2 |
Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 2 |
Rear Brake disc|s| excessively worn |3.2.A1l| | 2 |
Front Roller brake test indicates a sticking brake |3.3.A1a| | 2 |
Rear Floor brake test indicates a sticking brake |3.3.C2c| | 2 |
Rear Roller brake test indicates a sticking brake |3.3.A1a| | 2 |
Rear Locking devices not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 2 |
Offside Front Shock absorber has a serious fluid leak (5.3.2 (b)) | 2 |
Rear Brake component leaking fluid |3.2.B4| | 2 |
Front shock absorber seal failed and leaking oil |2.3.3| | 2 |
Rear Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 2 |
Rear Brake caliper has no reserve travel and braking performance affected (1.1.16 (e) (ii)) | 1 |
Horn not working |7.7 |a| |ii|| | 1 |
Rear Brake indicates excessive fluctuation of brake effort |1.2.1 |e|| | 1 |
Front Stop lamp damaged and function impaired |1.3.3a| | 1 |
Rear position lamp does not face the rear |1.1.1d| | 1 |
Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 1 |
Offside Direction indicators flashing more than 120 times per minute |1.5.1c| | 1 |
Handlebar deformed |2.1.1b| | 1 |
Steering control fouling between components which interferes with the free movement of the steering |2.1.2a| | 1 |
Central Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
Front Brake disc|s| has excessive run out |3.2.A1m| | 1 |
Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition |8.1.1 |a|| | 1 |
Fuel tank insecure |6.1.3 |a| |i|| | 1 |
Riders seat insecure |6.2.5 |a| |ii|| | 1 |
Rear reflector missing |4.8.2 |a| |ii|| | 1 |
Front Roller brake test indicates excessive fluctuation of brake effort |3.3.A1d| | 1 |
Rear Drive chain sprocket carrier worn to excess |6.2.1e| | 1 |
Steering control handlebar movement restricted by trapped cables |2.1.2c| | 1 |
Wheel alignment incorrect which adversely affects the steering |2.5.1| | 1 |
Headlamp insecure |1.2.3b| | 1 |
Rear Wheel alignment incorrect which adversely affects the handling |2.5.1| | 1 |
Front Front suspension has excessive stiffness in the suspension movement. |2.3.6b| | 1 |
Horn not working (7.7 (a) (ii)) | 1 |
Drive chain excessively loose (6.1.7 (c) (i)) | 1 |
Footrest missing |6.2.1a| | 1 |
Rear Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
Front Stop lamp remains on when the brake is released |1.3.1e| | 1 |
Offside Front Throttle operating incorrectly |6.2.1f| | 1 |
Front Fairing so located that it is likely to impede the steering |2.1.2e| | 1 |
Nearside Front Exhaust is leaking and excessively noisey |7.1.1b| | 1 |
Nearside Front Exhaust mounting missing |7.1.1c| | 1 |
Nearside Front Fairings insecure and likely to impede the steering |2.1.2e| | 1 |
Nearside Front Headlamp main beam affected by the operation of the horn |1.2.2c| | 1 |
Fuel system component insecure |7.2.1b| | 1 |
Offside Fairings insecure and likely to impede the steering |2.1.2e| | 1 |
Direction indicators not working |1.5.1c| | 1 |
Rear Rear wheel spindle securing nut locking device missing |2.4.A.2b| | 1 |
Exhaust mounting does not fully support the exhaust system |7.1.1.c| | 1 |
Offside Front Footrest insecure |6.2.1a| | 1 |
Offside Rear Footrest insecure |6.2.1a| | 1 |
Front Brake fluid reservoir fluid level dangerously low |3.2.B1d| | 1 |
Front Front wheel bearings are excessively rough |2.3.5b| | 1 |
Front Front wheel bearings have excessive free play |2.3.5b| | 1 |
Steering movement excessively `notchy` with the wheel raised |2.2.1b| | 1 |
Rear Roller brake test indicates excessive fluctuation of brake effort |3.3.A1d| | 1 |
Front Brake disc significantly and obviously worn |1.1.14 |a| |i|| | 1 |
Rear Stop lamp not working |4.3.1 |a| |ii|| | 1 |
Drive chain excessively loose |6.1.7 |c| |i|| | 1 |
Rear Brake pedal has inadequate reserve travel |3.1.3b| | 1 |
Riders seat insecure (6.2.5 (a) (ii)) | 1 |
Offside Front Direction indicators not working |1.5.1c| | 1 |
Offside Rear Direction indicators flashing more than 120 times per minute |1.5.1c| | 1 |
Centre Rear reflector on motorcycle missing |1.4.1| | 1 |
Rear Lower Engine mounting/bracket damaged or deteriorated resulting in excessive movement (6.1.8 (a) (i)) | 1 |
Front position lamp adversely affected by the operation of another lamp |1.1.3b| | 1 |
Nearside Rear Footrest insecure |6.2.1a| | 1 |
Rear reflector missing (4.8.2 (a) (ii)) | 1 |
Rear Stop lamp remains on when the brake is released |1.3.1e| | 1 |
Rear Brake disc|s| cracked |3.2.A1g| | 1 |
Nearside Handlebar handgrip not secure to handlebars. |2.1.1c| | 1 |
Offside Handlebar handgrip not secure to handlebars. |2.1.1c| | 1 |
Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b)) | 1 |
Front Valve stem seriously damaged (5.2.3 (j)) | 1 |
Rear Valve stem seriously damaged (5.2.3 (j)) | 1 |
Front Brake excessively binding (1.2.1 (f)) | 1 |
Rear Decelerometer brake test indicates a binding brake |3.3.E1d| | 1 |
Centre Rear Lower Exhaust is leaking and excessively noisey |7.1.1b| | 1 |
Rear Brake pedal pivots excessively worn |3.1.3a| | 1 |
Decelerometer brake test the less effective brake control does not achieve an efficiency of 25%. |3.3.E1b| | 1 |
Front Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 1 |
Nearside Front Direction indicator not working |1.5.1c| | 1 |
Fuel hose leaking |7.2.1a| | 1 |
Nearside Front Direction indicators affected by the operation of another lamp |1.5.1c| | 1 |
Brake lever is so short and the brake cannot be readily applied |3.1.3c| | 1 |
Front Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Rear wheel bearings are excessively rough |2.4.A.2c| | 1 |
Rear Wheel bearing play so excessive it is likely to break up |5.1.3 |a| |ii|| | 1 |
Front suspension has inadequate damping effect. |2.3.6c| | 1 |
Nearside Exhaust mounting missing |7.1.1c| | 1 |
Offside Exhaust mounting missing |7.1.1c| | 1 |
Headlamp aim beam image kick up to the offside |1.6| | 1 |
Offside Rear Footrest missing |6.2.1a| | 1 |
Rear suspension has corrosion which reduces the strength of a load bearing member or its supporting structure. |2.4.A.2d| | 1 |
Lower Motorcycle structure insecure and likely to affect the correct functioning of the steering or braking |6.1.1c| | 1 |
Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition |7.1.2| | 1 |
Rear Wheel bearing play so excessive that directional control is impaired (5.1.3 (a) (ii)) | 1 |
Rear Position lamp not working (4.2.1 (a)) | 1 |
Registration plate lamp issues | 1 |
Steering headbearing excessively stiff or notchy (2.2.2 (f) (i)) | 1 |
Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 1 |
Horn control defective |1.7.2a| | 1 |