| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 10 |
| Brakes imbalanced across an axle | 6 |
| Windscreen washer not working | 6 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 4 |
| Anti-lock braking system warning lamp indicates an ABS fault | 2 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
| Offside Side repeater not working (4.4.1 (a) (ii)) | 2 |
| Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Rear fog lamp not working |1.3.2b| | 1 |
| Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Suspension arm pin or bush likely to become detached nearside front upper bush rubber split (5.3.4 (a) (ii)) | 1 |
| Offside Front Side repeater not working |4.4.1 |a| |ii|| | 1 |
| Nearside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen |3.5 |a|| | 1 |
| Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
| Offside Rear fog lamp does not emit a steady red light (4.5.4 (a)) | 1 |
| Central Front Brake valve insecure air valve loose prs done (1.1.7 (c)) | 1 |
| Nearside Front Upper Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Headlamp not working on dipped beam Flashing on/off all the time (4.1.1 (a) (ii)) | 1 |
| Body panel likely to become detached osr panel loose (6.2.1 (a) (ii)) | 1 |
| Axle king pin is loose in the axle beam nearside front (5.1.2 (d) (i)) | 1 |
| Suspension arm pin or bush excessively worn osf cone bush worn (5.3.4 (a) (i)) | 1 |
| Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Offside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Nearside Headlamp aim not tested (4.1.2 (b)) | 1 |
| Offside Headlamp aim not tested (4.1.2 (b)) | 1 |
| Rear Passengers seat insecure Rear row not secure (6.2.6 (a) (ii)) | 1 |
| Offside Inner Passengers seat backrest cannot be secured in the upright position. Upstairs 5th row (6.2.6 (a) (i)) | 1 |
| Nearside Inner Seat belt buckle not functioning as intended 2nd row upstairs (7.1.2 (d)) | 1 |
| Offside Inner Seat belt buckle not functioning as intended 8th row upstairs (7.1.2 (d)) | 1 |
| Nearside Direction indicator not working |1.4.A.2c| | 1 |
| Offside Front Suspension pipe leaking PRS DONE (5.3.5 (c)) | 1 |
| Nearside Front Position lamp not working PRS DONE (4.2.1 (a) (ii)) | 1 |
| Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember (5.3.6 (a) (i)) | 1 |
| Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember holed both sides (5.3.6 (a) (i)) | 1 |
| Nearside Front Stub axle has excessive vertical movement between stub axle and axle beam (5.1.2 (c) (i)) | 1 |
| Offside Front Stub axle has excessive vertical movement between stub axle and axle beam (5.1.2 (c) (i)) | 1 |
| Nearside Side repeater not working (4.4.1 (a) (ii)) | 1 |
| Offside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Rear Lower Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii)) | 1 |
| Nearside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
| Nearside Front Axle king pin so loose it is likely to affect directional stability (5.1.2 (d) (ii)) | 1 |
| Offside Front Axle king pin so loose it is likely to affect directional stability (5.1.2 (d) (ii)) | 1 |
| Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
| Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b)) | 1 |
| Front Braking system leaking (1.1.3 (d)) | 1 |
| Rear fog lamp switch not operating in accordance with the requirements (4.5.3 (a)) | 1 |
| Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Rear fog lamp switch not operating in accordance with the requirements no tell tale (4.5.3 (a)) | 1 |
| Offside Front Axle king pin is loose in the axle beam (5.1.2 (d) (i)) | 1 |