| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 8 |
| Brakes imbalanced across an axle | 8 |
| Registration plate lamp issues | 6 |
| Rear brake binding | 6 |
| Parking brake: efficiency below requirements |3.7.B.7| | 5 |
| Service brake efficiency below requirements |1.2.2 |a| |i|| | 2 |
| Parking brake efficiency below requirements |1.4.2 |a| |i|| | 2 |
| Service brake: efficiency below requirements |3.7.B.7| | 2 |
| Offside rear brake recording little or no effort |3.7.B.5a| | 2 |
| Rear parking brake recording little or no effort | 2 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 2 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 2 |
| Parking brake lever has no reserve travel |3.1.6b| | 2 |
| Nearside Rear Direction indicator not working |1.4.A.2c| | 2 |
| Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Stop lamp not working |1.2.1b| | 2 |
| Horn not working |1.6.2a| | 2 |
| Battery insecure |1.9.1| | 2 |
| Windscreen washer not working | 1 |
| Windscreen wiper not working (3.4 (a)) | 1 |
| All direction indicators not working (4.4.1 (a) (ii)) | 1 |
| Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL (5.3.6 (a) (i)) | 1 |
| Stop lamp(s) switch with a delay in operation (4.3.2 (a) (ii)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Nearside Front Headlamp light intensity severely reduced |4.1.4 |a|| | 1 |
| Offside Front Headlamp light intensity severely reduced |4.1.4 |a|| | 1 |
| Nearside Rear Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
| Exhaust emissions - engine idle speed too high |8.2.1.2 |e|| | 1 |
| Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength front of spring mounting (5.3.6 (a) (i)) | 1 |
| Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Registration plate issues | 1 |
| Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
| Steering box insecure |2.2.B.1a| | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Offside Headlamp not working on main beam |1.7.5a| | 1 |
| Brake hose damaged | 1 |
| Brake hose has insufficient room to move | 1 |
| Horn not working |7.7 |a| |ii|| | 1 |
| Driver`s seat moving inadvertently |6.2.5 |b| |ii|| | 1 |
| Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch |5.3.6 |a| |i|| | 1 |
| Parking brake lever has excessive movement indicating incorrect adjustment |1.1.6 |c|| | 1 |
| Nearside Front Direction indicator not working |1.4.A.2c| | 1 |
| Nearside Rear rear parking |secondary| brake grabbing severely |3.7.B.6b| | 1 |
| Nearside Front Upper Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front front brake binding |3.7.B.1| | 1 |
| Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
| Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Headlamp aim beam image kick up to the offside |1.8| | 1 |
| Nearside Rear Lower Seat belt anchorage prescribed area is excessively corroded SILL |5.2.6| | 1 |
| Centre Rear Lower Seat belt anchorage prescribed area is excessively corroded SILL |5.2.6| | 1 |
| Offside Rear Lower Seat belt anchorage prescribed area is excessively corroded SILL |5.2.6| | 1 |
| Offside Front Brake hose kinked |3.6.B.4b| | 1 |
| Nearside Headlamp insecure |1.7.3| | 1 |
| Nearside Stop lamp emits other than a steady red light |1.2.1e| | 1 |
| Nearside Rear Direction indicator incorrect colour |1.4.A.2f| | 1 |
| An item not tested |Manual| | 1 |
| Nearside Front Shock absorber insecure |2.7.2b| | 1 |
| Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Offside Front Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Nearside Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Nearside Rear Upper Seat belt anchorage prescribed area is inadequately repaired |5.2.6| | 1 |
| Nearside Ball joint has excessive play track rod inner and outer joints |2.2.B.1f| | 1 |
| Direction indicators not working |1.4.A.2c| | 1 |
| Direction indicators flashing less than 60 times a minute |1.4.A.2g| | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Front brake application uneven | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Brake hose twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |
| Offside Front Upper Suspension arm insecure |2.4.G.1| | 1 |
| Offside Front Upper Suspension arm attachment bracket/mounting insecure |2.4.G.1| | 1 |
| Offside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Exhaust engine idle speed too high |7.3.A.2a| | 1 |
| Headlamp switch insecure |1.7.1| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Headlamp aim beam image kick up to the offside |1.8| | 1 |
| Offside Headlamp aim beam image kick up to the offside |1.8| | 1 |
| Fuel pipe insecure |7.2.1| | 1 |
| Nearside Front Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Nearside Front Headlamp not working on main beam |1.7.5a| | 1 |
| Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
| Offside Front Headlamp has a product on the light source so that the light output is severely reduced |1.7.5a| | 1 |
| Offside Front front brake binding |3.7.B.1| | 1 |
| Rear Stop lamp not working |1.2.1b| | 1 |
| Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
| Service brake: efficiency below requirements |3.7.C.1a| | 1 |
| Offside Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Front Lower Suspension component ball joint excessively worn |5.3.4 |a| |i|| | 1 |
| Brake lever has insufficient reserve travel |1.1.2 |a|| | 1 |
| Offside Rear Service brake has no recorded effort at a wheel |1.2.1 |a| |ii|| | 1 |
| Service brake efficiency less than 50% of the required value |1.2.2 |a| |ii|| | 1 |
| Parking brake efficiency less than 50% of the required value |1.4.2 |a| |ii|| | 1 |
| Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Rear Fuel system component leaking |7.2.3| | 1 |