| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 13 |
| Registration plate issues | 13 |
| Brake hose excessively deteriorated | 6 |
| Rear parking brake recording little or no effort | 5 |
| Parking brake: efficiency below requirements |3.7.B.7| | 5 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 4 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 4 |
| Brakes imbalanced across an axle | 4 |
| Offside Stop lamp not working |1.2.1b| | 3 |
| Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
| Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 3 |
| Rear brake application uneven | 3 |
| Nearside Stop lamp not working |1.2.1b| | 2 |
| Offside Front Direction indicators not working |1.4.A.2c| | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Front Front position lamp|s| not working |1.1.A.3b| | 2 |
| Parking brake lever has no reserve travel |3.1.6b| | 2 |
| Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
| Front brake application uneven | 2 |
| Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 2 |
| Registration plate lamp issues | 2 |
| Nearside Rear Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 2 |
| Offside Rear Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 2 |
| Offside Front Upper Suspension arm has excessive play in a pin/bearing |2.4.G.2| | 2 |
| Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Headlamp not working on main beam |1.7.5a| | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Front position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Front suspension has excessive play in a upper wishbone bearing |2.5.B.1a| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Rear Wheel bolt|s| missing |4.2.A.1e| | 1 |
| Offside front brake grabbing severely |3.7.A.2b| | 1 |
| Fuel cap/sealing device does not fasten securely by positive means |7.2.4b| | 1 |
| Fuel cap/sealing device sealing washer torn |7.2.4c| | 1 |
| Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Centre Front Brake actuating linkage mounting prescribed area is excessively corroded |3.3.A.2| | 1 |
| Offside Inner Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Braking system leaking |3.6.A.1| | 1 |
| Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 1 |
| Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Towbar mounting obviously of an inappropriate type |6.6.2| | 1 |
| Nearside Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Offside Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Exhaust has a major leak of exhaust gases silencer corroded |7.1.2| | 1 |
| Nearside Front Subframe mounting prescribed area is excessively corroded inner wing/inner sill holed |2.4.A.3| | 1 |
| Nearside Seat belt anchorage prescribed area is excessively corroded sill holed |5.2.6| | 1 |
| Horn not working |1.6.2a| | 1 |
| Offside Front Brake actuating linkage mounting prescribed area is excessively corroded inner wing hold and corroded |3.3.A.2| | 1 |
| front brake binding |3.7.B.1| | 1 |
| Brake performance not tested |3.7.A.1| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Front Windscreen washer control missing |8.2.1a| | 1 |
| Nearside Front Braking system leaking Brake hose to front caliper |3.6.A.1| | 1 |
| Nearside Rear Lower Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement Bush missing |2.4.G.2| | 1 |
| Offside Rear Lower Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement Bush missing |2.4.G.2| | 1 |
| Nearside Rear Upper Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Driver`s seat cannot be secured in the upright position. |6.2.A.2| | 1 |
| Brake performance not tested Due to leaking brake hose |3.7.A.1| | 1 |
| Service brake: efficiency below requirements |3.7.C.1a| | 1 |
| Horn sounds harsh or grating |1.6.2e| | 1 |
| Body has a sharp edge caused by corrosion bonnet |6.1.C.1| | 1 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings floorpan heater channel |6.1.B.2| | 1 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings floorpan/30cm seatbelt mount |6.1.B.2| | 1 |
| Parking brake lever defective so that it cannot be satisfactorily operated |3.1.3c| | 1 |
| Body has a sharp edge caused by corrosion rear bumper |6.1.C.1| | 1 |
| Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings seatbelt mount under rear seat bench |6.1.B.2| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings structure heater channel lower A post |6.1.B.2| | 1 |
| Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings firewall/bulkhead |6.1.B.2| | 1 |
| Offside Front Inner Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Exhaust system not adequately supported |7.1.1| | 1 |
| Offside Rear Shock absorber has an excessively worn bush |2.7.4| | 1 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings underbody floor pan |6.1.B.2| | 1 |
| Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings underbody floorpan |6.1.B.2| | 1 |
| Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings engine mount area underbody |6.1.B.2| | 1 |
| Rear Body insecure and dangerous to other road users under engine tinwear loose |6.1.B.1b| | 1 |
| Offside Front Lower Suspension arm has excessive play in a pin/bearing |2.4.G.2| | 1 |
| Nearside Front Upper Suspension arm insecure |2.4.G.1| | 1 |
| Offside Front Upper Suspension arm missing |2.4.G.1| | 1 |
| Offside Rear Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Offside Rear Upper Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Rear Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Offside Front front brake binding |3.7.B.1| | 1 |
| Upper Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
| Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
| Offside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
| Nearside Rear Mechanical brake component locking device missing |3.5.1l| | 1 |
| Front Direction indicators not working |1.4.A.2c| | 1 |
| Offside Front Suspension component mounting prescribed area is inadequately repaired inner arch at top mount area,previous repair not fully welded |2.4.A.3| | 1 |
| Bonnet cannot be secured in the closed position |8.4.1| | 1 |
| Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
| Offside Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
| Offside Rear Seat belt retracting mechanism defective |5.2.5b| | 1 |
| Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
| Front Suspension has inadequate clearance with the chassis |2.4.A.1a| | 1 |
| Rear Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
| brake disc excessively pitted |3.5.1h| | 1 |
| Fuel hose leaking |7.2.3| | 1 |
| Nearside Front Upper Suspension arm has excessive play in a pin/bearing |2.4.G.2| | 1 |
| Offside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front Upper Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear Direction indicator incorrect colour |1.4.A.2f| | 1 |
| Offside Rear Direction indicator incorrect colour |1.4.A.2f| | 1 |
| Fuel cap/sealing device sealing washer deteriorated |7.2.4c| | 1 |
| Rear Fuel pipe leaking |7.2.3| | 1 |
| Offside Lower Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Front Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
| Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Front Shock absorber has an excessively worn bush |2.7.4| | 1 |
| Offside Front Shock absorber has an excessively worn bush |2.7.4| | 1 |
| Nearside Rear Shock absorber has an excessively worn bush |2.7.4| | 1 |
| Front Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
| Nearside Front Sub-frame corroded and seriously weakened |2.4.G.1| | 1 |