Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 2 |
Headlamp aim out of alignment | 1 |
Nearside Headlamp insecure |1.7.3| | 1 |
Brake pump drive belt excessively deteriorated |3.6.F.1| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Inner Headlamp insecure |1.7.3| | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Brake cable has wires broken and is significantly weakened |3.5.1b| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Rear coil spring fractured |2.4.C.1a| | 1 |
Offside Rear Rear fog lamp not working |1.3.2b| | 1 |
Nearside Front Headlamp insecure |1.7.3| | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Windscreen has damage | 1 |
Nearside Rear coil spring fractured |2.4.C.1a| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Horn not working |1.6.2a| | 1 |
Offside Front Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
Nearside Front Anti-roll bar has excessive play in a ball joint |2.4.G.2| | 1 |
Brake linkage excessively worn and seriously weakened |3.5.1e| | 1 |
Offside Front Upper Suspension arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Headlamp insecure |1.7.3| | 1 |
Brake valve leaking |3.6.A.1| | 1 |
Rear brake application uneven | 1 |
Registration plate lamp issues | 1 |
Offside Rear Stop lamp emits other than a steady red light |1.2.1e| | 1 |
Offside Rear position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Driver`s door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
Nearside Inner Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Inner Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Rear coil spring incomplete |2.4.C.1a| | 1 |
Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Offside Front Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |