Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 6 |
Brake hose excessively deteriorated | 4 |
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Offside Rear fog lamp not working |1.3.2b| | 3 |
Registration plate lamp issues | 3 |
Rear parking brake recording little or no effort | 3 |
Horn not working |1.6.2a| | 3 |
Rear fog lamp tell tale not working |1.3.1b| | 2 |
Nearside Headlamp aim beam image kick up to the offside |1.8| | 2 |
Nearside Body has a sharp edge caused by damage |6.1.C.1| | 2 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Exhaust mounting missing |7.1.1b| | 1 |
Rear brake application uneven | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Rear fog lamp not working |1.3.2b| | 1 |
Parking brake mechanism/associated mounting prescribed area is excessively corroded cab floor |1.1.21 |e| |i|| | 1 |
Brake pipe leaking |3.6.A.1| | 1 |
Brake pipe excessively corroded | 1 |
Brake pedal creeps down while the pedal is held under pressure |3.3.B.1a| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Passenger`s seat insecure |6.2.A.1| | 1 |
Front brake application uneven | 1 |
Brakes imbalanced across an axle | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Front Side repeater not working |1.4.A.2c| | 1 |
Rear Brake linkage has restricted free movement |3.5.1k| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Brake lever has abnormal movement of levers indicating maladjustment |3.5.1f| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Offside Front Inner Parking brake mechanism/associated mounting prescribed area is excessively corroded sill |3.1.9| | 1 |
Nearside Rear Inner Suspension spring mounting prescribed area is excessively corroded valance |2.4.A.3| | 1 |
Offside Rear Inner Suspension spring mounting prescribed area is excessively corroded valance |2.4.A.3| | 1 |
Nearside Passenger`s seat insecure |6.2.A.1| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
rear parking |secondary| brakes imbalanced | 1 |
Speedometer cannot be illuminated. |6.7.3| | 1 |
Headlamp aim out of alignment | 1 |
Offside Rear coil spring incomplete |2.4.C.1a| | 1 |
Nearside Headlamp insecure |1.7.3| | 1 |
Centre Front Statutory seat belt missing |5.1.1| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Offside Side repeater excessively damaged so that it is not visible from a reasonable distance |1.4.A.2e| | 1 |
Exhaust has a part missing |7.1.1a| | 1 |
Indicator tell tale inoperative |1.4.A.2a| | 1 |
Centre Front Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
Nearside Front Upper Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Driver`s seat fore and aft adjustment mechanism not functioning as intended. |6.2.A.3| | 1 |