Most common failures | No# failures |
---|
Headlamp aim out of alignment | 5 |
Registration plate lamp issues | 4 |
Parking brake: efficiency below requirements |3.7.B.7| | 4 |
Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 3 |
Horn not working (7.7 (a) (ii)) | 2 |
Rear brake binding | 2 |
Nearside Outer Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings SILL |6.1.B.2| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings UNDER FLOOR |6.1.B.2| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings UNDER FLOOR |6.1.B.2| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings UNDER FLOOR |6.1.B.2| | 1 |
Offside Outer Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings SILL |6.1.B.2| | 1 |
Windscreen has damage | 1 |
Windscreen wiper blade insecure | 1 |
Offside Front Body panel damaged and likely to cause injury (6.2.1 (a) (i)) | 1 |
Horn sound not in accordance with requirements (7.7 (c)) | 1 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Nearside Front Brake inadequately mounted hose (1.1.21 (c)) | 1 |
Offside Front Brake inadequately mounted hose (1.1.21 (c)) | 1 |
Nearside Rear Brake inadequately mounted hose (1.1.21 (c)) | 1 |
Offside Rear Brake inadequately mounted hose (1.1.21 (c)) | 1 |
Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c)) | 1 |
Horn not working |1.6.2a| | 1 |
Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Nearside Front Steering rack gaiter split |2.2.D.2d| | 1 |
Offside Front Steering rack gaiter split |2.2.D.2d| | 1 |
Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings STEP AREA |6.1.B.2| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Rear fog lamp not working |1.3.2b| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Brakes imbalanced across an axle | 1 |
Nearside Obligatory mirror does not provide a view to the rear |3.3 |c|| | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Offside Steering rack gaiter split |2.2.D.2d| | 1 |
Rear parking brake recording little or no effort | 1 |
brake caliper inappropriately repaired o/s rattle shim broken and loose |3.5.1n| | 1 |
Nearside Front Brake pipe inadequately supported not fitted into mount and loose |3.6.B.1| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Fuel system component insecure plastic fuel pipe touching ex heat sheild |7.2.1| | 1 |
Body has a sharp edge caused by damage corner r bumpers |6.1.C.1| | 1 |
Battery insecure |1.9.1| | 1 |
Nearside Rear Wheel nut|s| loose |4.2.A.1e| | 1 |
Nearside Rear Wheel nut|s| missing |4.2.A.1e| | 1 |
Offside Front Anti-roll bar linkage insecure |2.4.G.1| | 1 |
Front Brake pipe likely to become detached or damaged rubbing on gear change rod (1.1.11 (d) (ii)) | 1 |
All direction indicators not working (4.4.1 (a) (ii)) | 1 |
Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b)) | 1 |
Horn not working (7.7 (a)) | 1 |
Nearside Rear Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Nearside Rear Inner Drive shaft securing bolt loose (6.1.7 (a) (i)) | 1 |