Most common failures | No# failures |
---|
Brake pipe excessively corroded | 3 |
Registration plate issues | 2 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 2 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Registration plate lamp issues | 2 |
Brakes imbalanced across an axle | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Rear Exhaust has a major leak of exhaust gases tail pipe |7.1.2| | 1 |
Nearside Front Front position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Nearside Front Body has a projection caused by corrosion door step |6.1.C.1| | 1 |
Offside Front Body has a projection caused by corrosion door step |6.1.C.1| | 1 |
Offside Front Upper Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
Exhaust engine idle speed too high |7.3.A.2a| | 1 |
Service brake: efficiency below requirements |3.7.C.1a| | 1 |
Parking brake: efficiency below requirements |3.7.C.1b| | 1 |
Nearside Front Brake performance not tested |3.7.A.1| | 1 |
Nearside Steering rack gaiter split |2.2.D.2d| | 1 |
Offside Steering rack gaiter split |2.2.D.2d| | 1 |
Nearside Rear Brake hose bulging under pressure |3.6.B.3| | 1 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |