Most common failures | No# failures |
---|
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Horn not working |1.6.2a| | 3 |
Service brake: efficiency below requirements |3.7.B.7| | 3 |
Headlamp aim out of alignment | 2 |
Nearside Windscreen wiper blade missing |8.2.2| | 1 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 1 |
Offside Rear Suspension arm corroded and seriously weakened holed (5.3.3 (b) (i)) | 1 |
Brake performance not tested |3.7.A.1| | 1 |
Front Braking system leaking |3.6.A.1| | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Rear Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Brake pipe excessively corroded | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front Front suspension has excessive play in a track control arm inner bush front bush |2.5.B.2b| | 1 |
Offside Front Front suspension has excessive play in a track control arm inner bush rear bush |2.5.B.2b| | 1 |
Nearside Rear Body has a sharp edge caused by damage wheel trim |6.1.C.1| | 1 |
Nearside Front Tie bar/rod rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Front Tie bar/rod rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Rear Braking system leaking |3.6.A.1| | 1 |
Brake hose excessively deteriorated | 1 |
Brake hose has insufficient room to move | 1 |
Offside Rear Drive shaft securing bolt missing One missing, some loose (6.1.7 (a) (i)) | 1 |
Windscreen wiper blade insecure | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Horn not working |7.7 |a| |ii|| | 1 |
Offside Front Position lamp not working |4.2.1 |a|| | 1 |
Nearside Front Brake hose bulging under pressure |3.6.B.3| | 1 |
Offside Rear Position lamp not working |4.2.1 |a|| | 1 |
Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt |2.1.3 |g| |ii|| | 1 |
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch | x2 | |5.3.6 |a| |i|| | 1 |
Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength |5.3.6 |a| |i|| | 1 |
Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt |5.3.4 |b| |ii|| | 1 |
Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt |5.3.4 |b| |ii|| | 1 |
Offside Front Brake pipe leaking |3.6.A.1| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings near fuel filler neck |6.1.B.2| | 1 |
Nearside Front Outer Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Front Outer Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Rear Hydraulic brake cylinder leaking hydraulic fluid |3.6.A.1| | 1 |