| Most common failures | No# failures |
|---|
| Brake pipe excessively corroded | 8 |
| Brake hose excessively deteriorated | 5 |
| Headlamp aim out of alignment | 3 |
| Registration plate lamp issues | 3 |
| Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 2 |
| Hazard warning tell tale not working correctly |1.4.B.1e| | 2 |
| Windscreen washer not working | 2 |
| Horn not working (7.7 (a)) | 2 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 2 |
| Offside Rear fog lamp not working |1.3.2b| | 2 |
| Offside Rear position lamp|s| not working |1.1.A.3b| | 2 |
| Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i)) | 2 |
| Parking brake: efficiency below requirements |3.7.B.7| | 2 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Stop lamp not working |1.2.1b| | 2 |
| Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Nearside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Offside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Power steering component leaking steering box (2.1.5 (a)) | 1 |
| Central Seat belt buckle missing (7.1.2 (d)) | 1 |
| Brake load sensing valve linkage defective and function impaired (1.1.17 (a)) | 1 |
| Brake performance not tested no park brake (1.2.1 (g)) | 1 |
| Offside Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
| Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
| Rear Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting BOTH SIDE ( above/behind rear wheel ) (6.2.2 (d) (i)) | 1 |
| All direction indicators not working (4.4.1 (a) (ii)) | 1 |
| Hazard warning lamps inoperative (4.4.1 (e)) | 1 |
| Offside Front Seat belt damaged (7.1.2 (b) (i)) | 1 |
| Speedometer clearly inoperative (7.8 (b) (ii)) | 1 |
| Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
| Offside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Central Prop shaft bearing excessively worn (6.1.7 (b) (i)) | 1 |
| Front Headlamp not working on dipped beam BOTH SIDE (4.1.1 (a) (ii)) | 1 |
| Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Front Shock absorbers has a serious fluid leak | 1 |
| Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Offside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Headlamp aim not tested |1.8.A.1c| | 1 |
| Nearside Rear Direction indicator not working (4.4.1 (a) (ii)) | 1 |
| Offside engine mounting bracket insecure and likely to fail |6.1.D.1b| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Headlamp insecure (4.1.1 (c)) | 1 |
| Nearside Front Shock absorbers has a serious fluid leak | 1 |
| Nearside Parking brake inoperative on one side (1.4.1 (a)) | 1 |
| Vehicle Identification Number not permanently displayed |6.3.5.a| | 1 |
| Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Side repeater not working |1.4.A.2c| | 1 |
| Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i)) | 1 |
| Rear Suspension component mounting prescribed area is excessively corroded inner sill, both sides |2.4.A.3| | 1 |
| Nearside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Nearside Front Suspension spring mounting prescribed area is excessively corroded inner wing |2.4.A.3| | 1 |
| Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
| Hazard warning lamps inoperative |1.4.B.1b| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Exhaust system not adequately supported |7.1.1| | 1 |
| Brake load sensing valve linkage seized |3.6.E.3| | 1 |
| Centre Exhaust mounting missing |7.1.1b| | 1 |
| Nearside Rear Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Horn not working |1.6.2a| | 1 |
| Brakes imbalanced across an axle | 1 |
| Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Hazard warning lamps inoperative all (4.4.1 (e)) | 1 |
| Nearside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
| Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Nearside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
| Offside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
| Hazard warning switch faulty |1.4.B.1d| | 1 |
| Stop lamp not working |1.2.1b| | 1 |
| Rear engine mounting deteriorated resulting in excessive movement |6.1.D.1a| | 1 |
| Rear parking brake recording little or no effort | 1 |
| Brake fluid warning lamp illuminated |3.6.G.2| | 1 |
| Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Suspension spring mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Nearside Front Subframe mounting prescribed area is excessively corroded inner sill |2.4.A.3| | 1 |
| Offside Front Subframe mounting prescribed area is excessively corroded sill |2.4.A.3| | 1 |
| Battery insecure carrier corrosion |1.9.1| | 1 |
| Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
| Offside Front Inner Suspension component mounting prescribed area is excessively corroded wing |2.4.A.3| | 1 |