| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 4 |
| Windscreen wiper does not clear the windscreen effectively | 4 |
| Registration plate issues | 4 |
| Brake hose excessively deteriorated | 3 |
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
| Brakes imbalanced across an axle | 2 |
| Nearside Stop lamp not working |1.2.1b| | 2 |
| Offside Stop lamp not working |1.2.1b| | 2 |
| Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 2 |
| Offside Front Shock absorber has a serious fluid leak |2.7.3| | 2 |
| Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Fuel pipe leaking |7.2.3| | 1 |
| Brake hose kinked |3.6.B.4b| | 1 |
| Offside Outer Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
| Nearside Outer Front constant velocity joint is insecure |2.5.C.1b| | 1 |
| Brake performance not tested |3.7.A.1| | 1 |
| Emissions not tested |7.0| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
| Windscreen wiper not working (3.4 (a)) | 1 |
| Headlamp not working on main beam o/s and n/s (4.1.1 (a) (ii)) | 1 |
| Exhaust has a major leak of exhaust gases front silncer box leaking and deteriorated (6.1.2 (a)) | 1 |
| Exhaust has a major leak of exhaust gases rear exhaust pipe leaking and deteriorated (6.1.2 (a)) | 1 |
| Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill panel (5.3.6 (a) (i)) | 1 |
| Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split and insecure (6.1.7 (g) (ii)) | 1 |
| Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split and leaking (6.1.7 (g) (ii)) | 1 |
| Emissions not tested due to coolant system issue (8.2.1.2 (d)) | 1 |
| Front Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Rear Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Front Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Rear Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Registration plate lamp issues | 1 |
| Offside Front Seat belt retracting mechanism defective |5.2.5b| | 1 |
| Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Offside Rear wheel bearing rough when rotated |2.6.1| | 1 |
| Rear brake application uneven | 1 |
| Brake hose damaged | 1 |
| Emissions not tested overheated (8.2.1.2 (d)) | 1 |
| Nearside Rear Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Lower Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Upper Suspension component mounting prescribed area so inadequately repaired that control of the vehicle is likely to be adversely affected inner wing |5.3.6 |a| |ii|| | 1 |
| Front Exhaust has a major leak of exhaust gases |6.1.2 |a|| | 1 |
| Nearside Front Lower Body has an unsafe modification wing. |6.2.1 |d| |i|| | 1 |
| Offside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected floor |5.3.6 |a| |ii|| | 1 |
| Horn not working |7.7 |a| |ii|| | 1 |
| Parking brake efficiency below requirements |1.4.2 |a| |i|| | 1 |
| Brake pedal has insufficient reserve travel |1.1.2 |a|| | 1 |
| Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength strut top mount (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Fuel hose leaking x2 under bonnet |7.2.3| | 1 |
| Stop lamp adversely affected by the operation of another lamp both |1.2.1f| | 1 |
| Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded by trailing arm |2.4.A.3| | 1 |
| Nearside Rear Rear wheel bearing has excessive play |2.6.2| | 1 |
| Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Rear wheel bearing has excessive play |2.6.2| | 1 |
| Offside Rear wheel bearing has excessive play |2.6.2| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Front Sub-frame has excessive play in a pin/bush |2.4.G.2| | 1 |