| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 6 |
| Brake hose excessively deteriorated | 4 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
| Offside Headlamp aim beam image kick up to the offside |1.8| | 3 |
| Parking brake: efficiency below requirements |3.7.B.7| | 3 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
| Registration plate lamp issues | 2 |
| Rear parking brake recording little or no effort | 2 |
| Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 2 |
| Offside Front Suspension arm corroded and seriously weakened |2.4.G.1| | 2 |
| Parking brake lever has no reserve travel |3.1.6b| | 2 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Rear brake binding | 2 |
| Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
| Front Upper Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Suspension component mounting prescribed area is excessively corroded excesive under body carrosion in prescribed areas and on componants |2.4.A.3| | 1 |
| Nearside Towbar retaining device missing |6.6.3a| | 1 |
| Rear Vehicle structure excessively corroded within 30cm of towbar mounting |6.6.6| | 1 |
| Parking brake efficiency below requirements |1.4.2 |a| |i|| | 1 |
| Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced wheelarch/inner wing excessive corrosion |7.1.1 |a| |i|| | 1 |
| Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced wheelarch/inner wing excessive corrosion |7.1.1 |a| |i|| | 1 |
| Nearside Front Body component corroded and likely to cause injury wheelarch |6.2.1 |a| |i|| | 1 |
| Offside Body component corroded and likely to cause injury sliding door |6.2.1 |a| |i|| | 1 |
| Nearside Front Sub-frame corroded and seriously weakened at top shock mount point |5.3.3 |b| |i|| | 1 |
| Nearside Rear Shock absorbers insecurely attached at top mounting |5.3.2 |a| |i|| | 1 |
| Nearside Rear Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
| Nearside Front Lower Suspension component ball joint dust cover no longer prevents the ingress of dirt split |5.3.4 |b| |ii|| | 1 |
| Offside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt |2.1.3 |g| |ii|| | 1 |
| Offside Front An item not tested |Manual| | 1 |
| Nearside Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Headlamp excessively deteriorated so that the light output is severely reduced |1.7.5a| | 1 |
| Headlamp aim out of alignment | 1 |
| Front passenger door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
| Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
| Offside Front Axle beam distorted |2.5.A.5b| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Nearside Front Axle beam cracked |2.5.A.5a| | 1 |
| Offside Vehicle structure excessively corroded within 30cm of towbar mounting |6.6.6| | 1 |
| Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings engine mounting |6.1.B.2| | 1 |
| Nearside Front Suspension arm corroded and seriously weakened |2.4.G.1| | 1 |
| Offside Direction indicator flashing more than 120 times a minute |1.4.A.2g| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded cross beam/section |2.4.A.3| | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded cross beam/ section |2.4.A.3| | 1 |
| Passenger`s seat insecure |6.2.A.1| | 1 |
| Offside Front Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
| Offside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
| Fuel cap/sealing device missing unable to check |7.2.4a| | 1 |
| Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Rear Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Nearside Rear Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
| Offside Windscreen wiper blade deteriorated |8.2.2| | 1 |
| Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
| Offside Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Nearside Body has a projection caused by corrosion |6.1.C.1| | 1 |
| Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Offside brake drum insecure |3.5.1i| | 1 |
| Nearside Direction indicator not working |1.4.A.2c| | 1 |
| Front passenger seat insecure |6.2.3| | 1 |
| Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Rear Mechanical brake component has restricted free movement | 1 |
| Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Upper Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Offside Outer Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Inner Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Nearside Direction indicator flashing more than 120 times a minute |1.4.A.2g| | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Offside Rear Shock absorber insecure |2.7.2b| | 1 |