| Most common failures | No# failures |
|---|
| Registration plate issues | 4 |
| Rear fog lamp not working |4.5.1 |a| |ii|| | 2 |
| Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b)) | 2 |
| Windscreen wiper does not clear the windscreen effectively | 2 |
| Rear fog lamp not working |1.3.2b| | 1 |
| Brake pedal spongy |3.3.B.1b| | 1 |
| Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
| Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 1 |
| Dipswitch does not operate immediately when selected on dipped beam |4.1.3 |b|| | 1 |
| Nearside Front seat belt pretensioner missing where fitted as original equipment |5.4.3a| | 1 |
| Offside Front seat belt pretensioner missing where fitted as original equipment |5.4.3a| | 1 |
| Rear fog lamp tell-tale not working |4.9.1 |a| |ii|| | 1 |
| Dipswitch does not operate immediately when selected on dipped beam (4.1.3 (b)) | 1 |
| Dipswitch does not operate immediately when selected on main beam (4.1.3 (b)) | 1 |
| Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 1 |
| Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b)) | 1 |
| Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c)) | 1 |
| Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b)) | 1 |
| Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
| Windscreen washer not working | 1 |
| Horn not working (7.7 (a)) | 1 |
| Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Hazard warning lamps inoperative (4.4.1 (e)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Brakes imbalanced across an axle | 1 |
| Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
| Headlamp aim out of alignment | 1 |
| Offside Front Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
| Offside Rear Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Nearside Rear Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b)) | 1 |
| Nearside Headlamp not working on main beam (4.1.1 (a) (ii)) | 1 |