Most common failures | No# failures |
---|
Brake hose excessively deteriorated | 4 |
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Headlamp aim out of alignment | 3 |
Rear parking brake recording little or no effort | 3 |
Registration plate lamp issues | 2 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Service brake: efficiency below requirements |3.7.C.1a| | 1 |
Direction indicators flashing more than 120 times a minute |1.4.A.2g| | 1 |
Indicator switch faulty |1.4.A.1| | 1 |
Horn not working |1.6.2a| | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Brake performance not tested |3.7.A.1| | 1 |
Nearside Rear Seat belt damaged sufficient to obstruct correct operation of the belt |5.2.2a| | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Centre Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Brake pipe inadequately clipped |3.6.B.1| | 1 |
Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Parking brake efficiency below requirements |1.4.2 |a| |i|| | 1 |
Driver`s view of the road through the swept area of the windscreen materially affected by an obstruction |3.1 |a| |ii|| | 1 |
Nearside Parking brake inoperative on one side |1.4.1 |a|| | 1 |
Offside Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
Brake pipe excessively corroded | 1 |
Offside Rear Service brake excessively binding |1.2.1 |f|| | 1 |
Nearside Rear Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt |6.1.7 |g| |ii|| | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Rear brake binding | 1 |
Brake hose has insufficient room to move | 1 |
Drive shaft which forms part of the suspension coupling gaiter insecure to the extent that it no longer prevents the ingress of dirt etc Clips missing on both sides CV gaiters |2.4.G.4e| | 1 |
Rear brake application uneven | 1 |
Parking brake lever is fouling adjacent parts of the vehicle Fouling oil cooler pipes |3.1.6b| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Windscreen washer not working | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Headlamp not working on dipped beam both (4.1.1 (a) (ii)) | 1 |
Nearside Rear reflector missing (4.8.2 (a) (ii)) | 1 |