| Most common failures | No# failures |
|---|
| Brake hose excessively deteriorated | 3 |
| Headlamp aim out of alignment | 2 |
| Rear Exhaust has a major leak of exhaust gases |6.1.2 |a|| | 1 |
| Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 1 |
| Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Brakes imbalanced across an axle | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c| | 1 |
| Horn not working |1.6.2a| | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Rear brake application uneven | 1 |
| Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 1 |
| Offside Rear coil spring broken |2.4.C.1a| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner door area (7.1.1 (a) (i)) | 1 |
| Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner door area (7.1.1 (a) (i)) | 1 |
| Offside Cab steps in such a condition that it is likely to cause injury corroded / holed (6.2.8 (b)) | 1 |
| Passengers seat insecure rear facing seat (6.2.6 (a) (ii)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch / outrigger areas (5.3.6 (a) (i)) | 1 |
| Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch / outrigger areas (5.3.6 (a) (i)) | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch / outrigger areas (5.3.6 (a) (i)) | 1 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch / outrigger areas (5.3.6 (a) (i)) | 1 |
| Nearside Headlamp insecure main beam (4.1.1 (c)) | 1 |