| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 4 |
| Brake valve leaking (1.1.7 (d) (i)) | 2 |
| Nearside Rear Seat belt buckle missing rear bench seat |7.1.2 |d|| | 1 |
| Offside Rear Seat belt buckle missing rear bench seat |7.1.2 |d|| | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis has a hole from corrosion |5.3.6 |a| |i|| | 1 |
| Front brake excessively fluctuating | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Emissions not tested |7.3.A.1| | 1 |
| Nearside Rear Body has a sharp edge caused by damage |6.1.C.1| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Fuel cap/sealing device mounting flange/sealing method defective |7.2.4c| | 1 |
| Centre Rear Passenger`s seat insecure |6.2.A.1| | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
| Nearside Direction indicator adversely affected by the operation of another lamp Brake Light (4.4.3 (b)) | 1 |
| Rear Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Chassis leg (6.1.1 (c) (i)) | 1 |
| Offside Rear Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Drivers seat fore and aft adjustment mechanism not functioning as intended. (6.2.5 (b) (i)) | 1 |
| Offside Rear Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
| Nearside Rear Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |