Most common failures | No# failures |
---|
Headlamp aim out of alignment | 12 |
Registration plate lamp issues | 9 |
Rear parking brake recording little or no effort | 5 |
Horn not working |1.6.2a| | 5 |
Brake hose excessively deteriorated | 4 |
Parking brake: efficiency below requirements |3.7.B.7| | 4 |
Battery insecure |1.9.1| | 4 |
Windscreen washer not working | 4 |
Offside Stop lamp not working |1.2.1b| | 3 |
Exhaust has a major leak of exhaust gases |7.1.2| | 3 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
Offside Front position lamp|s| not working |1.1.A.3b| | 2 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 2 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Rear wheel bearing has excessive play |2.6.2| | 2 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Direction indicators flashing more than 120 times a minute |1.4.A.2g| | 2 |
Rear brake binding | 2 |
Service brake: efficiency below requirements |3.7.B.7| | 2 |
Nearside Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 2 |
Indicator switch insecure |1.4.A.1| | 2 |
Offside rear brake recording little or no effort |3.7.B.5a| | 2 |
Brakes imbalanced across an axle | 2 |
Nearside Front Upper Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 2 |
Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 2 |
Windscreen wiper not operating automatically when switched on |8.2.1b| | 2 |
Horn not working (7.7 (a) (ii)) | 2 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Brake hydraulic reservoir leaking hydraulic fluid |3.6.A.1| | 1 |
Nearside Front Wheel nut|s| loose |4.2.A.1e| | 1 |
Offside Rear Brake hose bulging under pressure |3.6.B.3| | 1 |
Nearside Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
Offside Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
Exhaust engine idle speed too high |7.3.A.2a| | 1 |
Nearside Front Anti-roll bar attachment bracket/mounting cracked |2.4.G.1| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Rear wheel bearing has excessive play |2.6.2| | 1 |
Offside Front Anti-roll bar attachment bracket/mounting corroded and its strength is seriously reduced |2.4.G.1| | 1 |
Front Mechanical brake component securing device loose |3.5.1i| | 1 |
Nearside Front brake caliper securing device loose |3.5.1j| | 1 |
Offside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Offside Headlamp aim beam image too far to the right |1.6.B4| | 1 |
Nearside Headlamp aim beam image too far to the left |1.6.B4| | 1 |
Indicator tell tale inoperative |1.4.A.2a| | 1 |
Nearside Front Direction indicators not working |1.4.A.2c| | 1 |
Driver`s door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
Nearside Front Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Front Lower Suspension arm ball joint dust cover insecure so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
Offside Front Direction indicator incorrect colour |1.4.A.2f| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Front Front position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Offside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Steering arm has relative movement at its fixings |2.2.B.1h| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Driver`s seat fore and aft adjustment mechanism not functioning as intended. |6.2.A.3| | 1 |
Nearside Vehicle structure excessively corroded within 30cm of towbar mounting cross member |6.6.6| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Ball joint has excessive play |2.2.B.1f| | 1 |
Offside Rear Position lamp adversely affected by the operation of another lamp & offside stop lamp |4.2.3 |c|| | 1 |
Offside Rear Direction indicator adversely affected by the operation of another lamp |4.4.3 |b|| | 1 |
Offside Steering lock stop incorrectly adjusted steering lock stop distorted & offside road wheel inner rim fouling suspension arms on full left hand lock |2.1.4 |b|| | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis rail excessively corroded within 30cms of front suspension axle beam mountings |5.3.6 |a| |i|| | 1 |
Offside Rear Rear reflector defective or damaged by more than 50% of the reflecting surface lamp lens excessively faded |4.8.1 |a| |ii|| | 1 |
Offside Front Upper Suspension arm ball joint excessively worn |5.3.4 |a| |i|| | 1 |
Nearside Front Wheel bearing has excessive play |5.1.3 |a| |i|| | 1 |
Front Axle beam cracked suspension axle beam excessively corroded & fractured on offside end |2.5.A.5a| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded chassis rail excessively corroded within 30 cms of front axle beam attachments |2.4.A.3| | 1 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Drag link end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Drag link end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Front Brake pipe fouled by moving parts |3.6.B.2a| | 1 |
Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition |7.1.4| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Centre Front Steering pivot point has excessive play |2.2.B.1g| | 1 |
Front brake application uneven | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front Seat belt damaged sufficient to obstruct correct operation of the belt |5.2.2a| | 1 |
Steering system has excessive free play detected at the steering wheel |steering box fitted| |2.2.A.1a| | 1 |
Front Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Brake pedal anti-slip provision missing |3.3.A.1b| | 1 |
Direction indicators not working |1.4.A.2c| | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Front position lamp|s| incorrect colour |1.1.A.3e| | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Headlamp does not operate immediately when selected on main beam |1.7.4a| | 1 |
Steering column top mounting bracket insecure |2.1.2d| | 1 |
Headlamp not working on main beam |1.7.5a| | 1 |
Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle beam corroded on offside & nearside adjacent to chassis mountings (5.3.6 (a) (i)) | 1 |
Offside Front Anti-roll bar attachment bracket/mounting corroded and seriously weakened suspension anti-roll bar clamp corroded & fractured (5.3.3 (b) (i)) | 1 |
Exhaust has a major leak of exhaust gases exhaust silencer casing corroded & holed (6.1.2 (a)) | 1 |
Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i)) | 1 |
Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii)) | 1 |
Exhaust has a major leak of exhaust gases at manifold joints (6.1.2 (a)) | 1 |
Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a)) | 1 |
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |