Most common failures | No# failures |
---|
Service brake: efficiency below requirements |3.7.B.7| | 16 |
Parking brake: efficiency below requirements |3.7.B.7| | 9 |
Brakes imbalanced across an axle | 8 |
Windscreen wiper does not clear the windscreen effectively | 8 |
Brake hose excessively deteriorated | 7 |
Headlamp aim out of alignment | 6 |
Registration plate lamp issues | 4 |
Exhaust mounting missing |7.1.1b| | 3 |
Nearside Headlamp not working on main beam |1.7.5a| | 3 |
Rear parking brake recording little or no effort | 3 |
Parking brake lever has no reserve travel |3.1.6b| | 3 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 3 |
Brake pipe excessively corroded | 3 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 3 |
Nearside Steering pivot point has excessive play |2.2.B.1g| | 2 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 2 |
Rear brake binding | 2 |
Offside rear brake recording little or no effort |3.7.B.5a| | 2 |
Rear Brake load sensing valve linkage seized |3.6.E.3| | 2 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 2 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Nearside Front Direction indicators not working |1.4.A.2c| | 2 |
Centre Exhaust mounting missing |7.1.1b| | 2 |
Stop lamp not working |1.2.1b| | 2 |
Horn not working |1.6.2a| | 2 |
Front brake disc in such a condition that it is seriously weakened | 2 |
Nearside Front Track rod end ball joint has excessive play |2.2.B.1f| | 2 |
Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Offside Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Upper Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Front Upper Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Brake pedal has no servo assistance |3.3.B.2| | 1 |
Rear Brake load sensing valve seized |3.6.E.3| | 1 |
Position lamp switch faulty |1.1.A.1| | 1 |
Brake pedal anti-slip provision worn smooth |3.3.A.1b| | 1 |
Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 1 |
Nearside Inner Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Inner Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
Offside Front Axle has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Brake valve leaking |3.6.A.1| | 1 |
Nearside Battery insecure |1.9.1| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Inner Ball joint has excessive play |2.2.B.1f| | 1 |
Offside Inner Ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Nearside Inner Ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Centre Front Brake pipe inadequately clipped |3.6.B.1| | 1 |
Nearside Rear Leaf spring longitudinally displaced |2.4.B.1d| | 1 |
Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Direction indicators not working |1.4.A.2c| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Hazard warning tell tale not working correctly |1.4.B.1e| | 1 |
Offside Front Direction indicators not working |1.4.A.2c| | 1 |
Indicator tell tale inoperative |1.4.A.2a| | 1 |
Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Battery insecure |1.9.1| | 1 |
Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Front Brake pipe inadequately supported |3.6.B.1| | 1 |
Offside Front Brake pipe inadequately clipped |3.6.B.1| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Body has a projection caused by damage |6.1.C.1| | 1 |
Parking brake lever ratchet mechanism is excessively worn |3.1.5| | 1 |
Parking brake lever defective so that it cannot be satisfactorily operated |3.1.3c| | 1 |
Parking brake lever pawl spring does not push the pawl positively into the ratchet teeth |3.1.5| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Offside Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
Rear Exhaust mounting missing |7.1.1b| | 1 |
Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Upper Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Front Upper Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Registration plate issues | 1 |
Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Nearside Ball joint has excessive play |2.2.B.1f| | 1 |
Nearside Front Direction indicator not working |1.4.A.2c| | 1 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Front brake disc excessively pitted |3.5.1h| | 1 |
Offside Front brake disc excessively pitted |3.5.1h| | 1 |
Emissions not tested |7.0| | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Offside Front Wheel nut|s| loose |4.2.A.1e| | 1 |
Offside Steering pivot point has excessive play |2.2.B.1g| | 1 |
Offside Front brake caliper leaking |3.6.A.1| | 1 |
Rear Brake valve leaking load sensing valve leaking |3.6.A.1| | 1 |
Stop lamp|s| all not working |4.3.1 |a| |iii|| | 1 |
Emission control equipment obviously defective |8.2.1.1 |a|| | 1 |
Nearside Front Upper Suspension arm ball joint excessively worn |5.3.4 |a| |i|| | 1 |
Offside Front Upper Suspension arm ball joint excessively worn |5.3.4 |a| |i|| | 1 |
Nearside Rear reflector missing |1.5.1a| | 1 |
Nearside Front Mechanical brake component locking device missing |3.5.1l| | 1 |
Offside Front Mechanical brake component locking device missing |3.5.1l| | 1 |
Nearside Front Side repeater not working |1.4.A.2c| | 1 |
Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Hazard warning switch missing |1.4.B.1d| | 1 |
Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Offside Front Ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |