Most common failures | No# failures |
---|
Headlamp aim out of alignment | 4 |
Rear brake application uneven | 3 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Service brake: efficiency below requirements |3.7.B.7| | 2 |
Brake pipe excessively corroded | 2 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Offside Front Parking brake mechanism/associated mounting prescribed area is excessively corroded |3.1.9| | 1 |
Offside Stop lamp insecure |1.2.1a| | 1 |
Rear fog lamp insecure |1.3.2a| | 1 |
Nearside Front Brake hose excessively damaged |3.6.B.4d| | 1 |
Nearside Inner Front Upper Suspension arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Battery insecure |1.9.1| | 1 |
Steering system excessively tight |2.2.D.1| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Nearside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Rear Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
Offside Rear Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
Nearside Front Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
Offside Front Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
Offside Front Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Upper Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Front Upper Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Brake hose excessively deteriorated | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
front brake binding |3.7.B.1| | 1 |