Most common failures | No# failures |
---|
Brake hose excessively deteriorated | 7 |
Parking brake: efficiency below requirements |3.7.B.7| | 5 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 4 |
Headlamp aim out of alignment | 4 |
Registration plate lamp issues | 4 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Offside Steering rack gaiter split |2.2.D.2d| | 3 |
Brake pipe excessively corroded | 3 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 3 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
Offside Front Front constant velocity joint gaiter split |2.5.C.1a| | 2 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Brake hose damaged | 2 |
Offside Rear Sub-frame rubber bush bonding deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Macpherson strut has excessive movement at the upper attachment |2.5.A.1c| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Nearside Headlamp excessively damaged so that the light output is severely reduced |1.7.5a| | 1 |
Rear wheel bearing has excessive play |2.6.2| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Rear brake application uneven | 1 |
Nearside Headlamp aim not tested |1.8.A.1c| | 1 |
Offside Headlamp aim beam image too far to the left |1.6.B4| | 1 |
Nearside Rear wheel bearing has excessive play |2.6.2| | 1 |
Offside Rear wheel bearing has excessive play |2.6.2| | 1 |
Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Nearside Front Bonded suspension unit deteriorated and cannot function as intended |2.4.F.3| | 1 |
Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 1 |
Windscreen has damage | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Rear parking brake recording little or no effort | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
Registration plate issues | 1 |
Fuel system component leaking |7.2.3| | 1 |
Nearside Rear Statutory seat belt missing |5.1.1| | 1 |
Offside Rear Upper Statutory seat belt missing |5.1.1| | 1 |
Brake pedal has insufficient reserve movement |3.3.A.5| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front Brake pipe inadequately supported |3.6.B.1| | 1 |
Nearside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
brake disc cracked |3.5.1h| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear Seat belt flexible stalk deteriorated likely to lead to failure under load |5.2.4a| | 1 |
Offside Front Macpherson strut has excessive movement at the upper attachment |2.5.A.1c| | 1 |
Offside Front Lower Suspension arm rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Offside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Horn not working |1.6.2a| | 1 |
Offside Front Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Front constant velocity joint gaiter insecurely mounted to its housing |2.5.C.1a| | 1 |
Offside Front Direction indicator not working |1.4.A.2c| | 1 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Front Road wheel bead rim badly distorted |4.2.A.1a| | 1 |
Rear Exhaust mounting missing |7.1.1b| | 1 |
Offside Front Headlamp missing |1.7.3| | 1 |
Offside Front Headlamp not working on main beam |1.7.5a| | 1 |
Rear Rear fog lamp not working |1.3.2b| | 1 |
Nearside Rear All position lamps not working |1.1.A.3b| | 1 |
Offside Front Sub-frame attachment bracket/mounting insecure |2.4.G.1| | 1 |
Offside Front Lower Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Nearside Rear Sub-frame rubber bush bonding deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Rear Body has a projection caused by damage |6.1.C.1| | 1 |
Offside Front Body has a projection caused by damage |6.1.C.1| | 1 |