| Most common failures | No# failures |
|---|
| Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 2 |
| Brakes imbalanced across an axle | 2 |
| Brake hose excessively deteriorated | 2 |
| Headlamp aim out of alignment | 2 |
| Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Offside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
| Offside front brake binding |3.7.B.1| | 1 |
| Horn not working |7.7 |a| |ii|| | 1 |
| Offside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen jet not secure |3.5 |a|| | 1 |
| Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced |7.1.1 |a| |i|| | 1 |
| Brake lever has insufficient reserve travel |1.1.2 |a|| | 1 |
| Parking brake efficiency less than 50% of the required value |1.4.2 |a| |ii|| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Upper Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
| Brake pipe excessively corroded | 1 |
| Nearside Front front brake binding |3.7.B.1| | 1 |
| Front brake application uneven | 1 |
| Offside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i)) | 1 |
| Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
| Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 1 |
| Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b)) | 1 |
| Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Front Service brake excessively binding (1.2.1 (f)) | 1 |
| Horn not working (7.7 (a)) | 1 |
| Registration plate lamp issues | 1 |
| Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Offside Rear Upper Suspension component mounting prescribed area is excessively corroded inner wheel arch |2.4.A.3| | 1 |
| Offside Front Brake hose bulging under pressure |3.6.B.3| | 1 |
| Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
| Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |