Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 8 |
Headlamp aim out of alignment | 6 |
Registration plate lamp issues | 4 |
Brakes imbalanced across an axle | 4 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 4 |
Brake hose excessively deteriorated | 3 |
Offside Stop lamp not working |1.2.1b| | 2 |
Horn not working |1.6.2a| | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Rear brake binding | 2 |
Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 2 |
Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Exhaust emissions hydrocarbon content excessive |7.3.B.1b| | 2 |
Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
Offside Steering rack gaiter split |2.2.D.2d| | 1 |
Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both outer sills near rear trailing arm mounts |5.3.6 |a| |i|| | 1 |
Exhaust emissions carbon monoxide content excessive |8.2.1.2 |b|| | 1 |
Offside Rear Position lamp not working |4.2.1 |a|| | 1 |
Stop lamp|s| not working both sides |4.3.1 |a| |ii|| | 1 |
Nearside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt |5.3.4 |b| |ii|| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Brake pipe inadequately supported |3.6.B.1| | 1 |
Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Nearside Rear Coil spring not correctly located |2.4.C.2| | 1 |
Offside Rear Coil spring not correctly located |2.4.C.2| | 1 |
Offside Windscreen wiper not operating over a large enough area to give an adequate view |8.2.1c| | 1 |
Parking brake inoperative on one side both sides efficiency down (1.4.1 (a)) | 1 |
Nearside Front Direction indicator not working (4.4.1 (a) (ii)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Fuel cap/sealing device missing cap |7.2.4a| | 1 |
Nearside Vehicle structure has an inadequate repair, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Suspension arm corroded and seriously weakened |2.4.G.1| | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Registration plate issues | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded front inner wheel arch |2.4.A.3| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings engine component |6.1.B.2| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings engine component |6.1.B.2| | 1 |
Nearside Front Seat belt anchorage prescribed area is excessively corroded inner wheel arch |5.2.6| | 1 |
Nearside Front Upper Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
Nearside Rear Suspension arm corroded and seriously weakened |2.4.G.1| | 1 |
Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b)) | 1 |
Offside Front Brake pipe at imminent risk of failure or fracture to calliper (1.1.11 (a)) | 1 |
Brake performance not tested burst pipe (1.2.1 (g)) | 1 |
Horn not working (7.7 (a) (ii)) | 1 |
Offside Rear Service brake excessively binding |1.2.1 |f|| | 1 |
Offside Front Service brake excessively binding |1.2.1 |f|| | 1 |
Exhaust emissions hydrocarbon content excessive |8.2.1.2 |b|| | 1 |
Exhaust has a part missing |7.1.1a| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Rear Brake pipe inadequately clipped to brake hose |3.6.B.1| | 1 |
Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Fuel tank leaking |7.2.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Hazard warning switch faulty |1.4.B.1d| | 1 |
Nearside Front brake disc excessively pitted |3.5.1h| | 1 |
Offside Front brake disc excessively pitted |3.5.1h| | 1 |
Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Rear Rear fog lamp not working |1.3.2b| | 1 |
Nearside Front Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Front Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c)) | 1 |
Nearside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill/lower quarter (5.3.6 (a) (i)) | 1 |
Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength centre sill corroded on seam (5.3.6 (a) (i)) | 1 |
Offside Rear Brake drum back plate insecure heavily holed and corroded around mounting bolts to axle (1.1.14 (d)) | 1 |
Offside Rear Brake insecure trailing brake shoe retaining pin/spring missing leaving shoe insecure (1.1.21 (c)) | 1 |
Nearside Exhaust has a major leak of exhaust gases front exhaust pipe to cylinder head (6.1.2 (a)) | 1 |
Offside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii)) | 1 |
Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b)) | 1 |
Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floors (7.1.1 (a) (i)) | 1 |
Hazard warning lamps inoperative (4.4.1 (e)) | 1 |
Indicator tell tale inoperative |1.4.A.2a| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i)) | 1 |
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i)) | 1 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Front Service brake excessively binding (1.2.1 (f)) | 1 |