Most common failures | No# failures |
---|
Brake pipe excessively corroded | 8 |
Registration plate lamp issues | 7 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 6 |
Brake hose excessively deteriorated | 5 |
Windscreen wiper does not clear the windscreen effectively | 4 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 4 |
Rear Exhaust system not adequately supported |7.1.1| | 4 |
Headlamp aim out of alignment | 4 |
Exhaust has a major leak of exhaust gases |7.1.2| | 3 |
Rear brake binding | 2 |
Brakes imbalanced across an axle | 2 |
Horn not loud enough to be heard by another road user |1.6.2b| | 2 |
Registration plate issues | 2 |
Offside Front Hazard warning lamps inoperative |1.4.B.1b| | 2 |
Offside Rear Hazard warning lamps inoperative |1.4.B.1b| | 2 |
Offside front brake binding |3.7.B.1| | 2 |
Nearside Rear coil spring broken |2.4.C.1a| | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength radius arm mounting area (5.3.6 (a) (i)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Nearside Front Direction indicator not working |1.4.A.2c| | 1 |
Offside Front Direction indicator not working |1.4.A.2c| | 1 |
Front Hazard warning lamps inoperative |1.4.B.1b| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Nearside Rear Suspension arm corroded and seriously weakened marked yellow (5.3.3 (b) (i)) | 1 |
Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced suspension arm mounting area, marked yellow (6.1.1 (c) (i)) | 1 |
Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced suspension arm mounting area, marked yellow (6.1.1 (c) (i)) | 1 |
Offside Rear Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Offside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Nearside Brake cable has wires broken and is significantly weakened |3.5.1b| | 1 |
Brake pipe inadequately supported |3.6.B.1| | 1 |
Front Brake pipe inadequately supported |3.6.B.1| | 1 |
Nearside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Nearside Front Brake pipe kinked |3.6.B.2b| | 1 |
Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting |6.6.6| | 1 |
Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting |6.6.6| | 1 |
Nearside Rear wheel bearing has excessive play |2.6.2| | 1 |
Offside Rear wheel bearing has excessive play |2.6.2| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Nearside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
Offside Direction indicators not working |1.4.A.2c| | 1 |
Offside Rear Drive shaft which forms part of the suspension coupling gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.4.G.4e| | 1 |
Speedometer cannot be illuminated |7.8 |c| |ii|| | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill corroded |5.3.6 |a| |i|| | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer suspension arm bracket corroded on inner section of bracket |5.3.6 |a| |i|| | 1 |
Horn not working |1.6.2a| | 1 |
Offside Rear Drive shaft which forms part of the suspension coupling gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.4.G.4e| | 1 |
Nearside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
Rear parking brake recording little or no effort | 1 |
Nearside Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Emissions not tested |7.0| | 1 |
Offside Hazard warning lamps inoperative |1.4.B.1b| | 1 |
Offside Front Steering rack gaiter insecure |2.2.D.2d| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Speedometer cannot be illuminated. |6.7.3| | 1 |
Nearside Rear Direction indicator not working |1.4.A.2c| | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Nearside Front Upper Suspension arm rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Vehicle Identification Number not permanently displayed |6.3.5.a| | 1 |
Offside Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Lower Suspension arm corroded and seriously weakened |2.4.G.1| | 1 |
Nearside Rear coil spring fractured |2.4.C.1a| | 1 |
Rear brake application uneven | 1 |
Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 1 |
Nearside Front Lower Tie bar/rod rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Front Upper Anti-roll bar has excessive play in a pin/bush |2.4.G.2| | 1 |
Offside Front Front position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Front Body has a sharp edge caused by corrosion outer sill corroded |6.1.C.1| | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Nearside Front Body has a sharp edge caused by corrosion passenger step corroded |6.1.C.1| | 1 |
Nearside Rear brake drum in such a condition that it is seriously weakened back plate excessively corroded |3.5.1i| | 1 |
Offside Rear brake drum in such a condition that it is seriously weakened back plate excessively corroded |3.5.1i| | 1 |
Horn not working (7.7 (a) (ii)) | 1 |
Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |