Most common failures | No# failures |
---|
Headlamp aim out of alignment | 6 |
Rear brake binding | 3 |
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 2 |
Offside Headlamp insecure |1.7.3| | 2 |
Front Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Horn not working |1.6.2a| | 1 |
Rear Ball joint ball pin shank loose |2.2.B.1c| | 1 |
Horn not working works all the time |1.6.2a| | 1 |
passenger door cannot be opened from outside the vehicle slide door |6.2.B.1c| | 1 |
Rear Rear position lamp|s| adversely affected by the operation of another lamp both |1.1.A.3f| | 1 |
Ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Electrical wiring damaged and bare wires exposed |1.9.2c| | 1 |
Headlamp not working on dipped beam both |1.7.5a| | 1 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Exhaust emits clearly visible black smoke during acceleration |7.3.A.2c| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Front passenger door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
Front brake application uneven | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Headlamp insecure |1.7.3| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Steering column top mounting bracket insecure |2.1.2d| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front An item not tested |Manual| | 1 |
Offside front brake juddering severely |3.7.A.2b| | 1 |
Rear parking brake recording little or no effort | 1 |
Brakes imbalanced across an axle | 1 |
Steering column movement between the shaft and steering wheel |2.1.2b| | 1 |
Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Offside Front Lower Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) | 1 |
Nearside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings door step |6.1.B.2| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings axle |6.1.B.2| | 1 |