Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 4 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 3 |
Headlamp aim out of alignment | 3 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Parking brake lever has no reserve travel |3.1.6b| | 2 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 2 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Windscreen has damage | 1 |
Offside Front Brake hose twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |
Offside Front Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Offside Stop lamp emits other than a steady red light |1.2.1e| | 1 |
Offside Front Brake actuating linkage mounting prescribed area is excessively corroded |3.3.A.2| | 1 |
Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Hazard warning lamps inoperative |1.4.B.1b| | 1 |
Offside Rear Hazard warning lamps inoperative |1.4.B.1b| | 1 |
Registration plate lamp issues | 1 |
Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone `A` |8.3.1b| | 1 |
Nearside Seat belt locking mechanism does not secure or release |5.2.5a| | 1 |
Brake pipe excessively corroded | 1 |
Nearside Front Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Drag link end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Rear Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Parking brake: efficiency below requirements |3.7.C.1b| | 1 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Jacking point |6.1.B.2| | 1 |