Most common failures | No# failures |
---|
Headlamp aim out of alignment | 8 |
Registration plate lamp issues | 6 |
Windscreen wiper does not clear the windscreen effectively | 5 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 4 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 3 |
Offside Rear wheel bearing has excessive play |2.6.2| | 2 |
Emissions not tested |7.0| | 2 |
Offside Rear fog lamp not working |1.3.2b| | 2 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Nearside Stop lamp not working |1.2.1b| | 2 |
Nearside Rear wheel bearing has excessive play |2.6.2| | 2 |
Centre Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Offside Stop lamp not working |1.2.1b| | 2 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded under door sill |2.4.A.3| | 1 |
Nearside Track rod end loose |2.2.B.1d| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Stop lamp excessively damaged so that it is not visible from a reasonable distance |1.2.1d| | 1 |
Rear fog lamp tell tale not working |1.3.1b| | 1 |
Horn not working |1.6.2a| | 1 |
Offside Direction indicators incorrect colour |1.4.A.2f| | 1 |
Nearside Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Rear An item not tested |Manual| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Rear Rear fog lamp not working |1.3.2b| | 1 |
Rear Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Front Headlamp excessively deteriorated so that the light output is severely reduced |1.7.5a| | 1 |
Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded axle beam |2.4.A.3| | 1 |
Rear Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Offside Rear wheel bearing rough when rotated |2.6.1| | 1 |
Exhaust emissions carbon monoxide content at idle excessive |7.3.D.4| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Direction indicators incorrect colour |1.4.A.2f| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded axle beam |2.4.A.3| | 1 |
Brake pipe excessively corroded | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Rear fog lamp not working |1.3.2b| | 1 |
Nearside Front Seat belt obviously repaired |5.2.2c| | 1 |
Exhaust emissions hydrocarbon content after 2nd fast idle excessive |7.3.D.3| | 1 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Inner Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |