| Most common failures | No# failures |
|---|
| Rear brake application uneven | 3 |
| Headlamp aim out of alignment | 3 |
| Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 3 |
| Brakes imbalanced across an axle | 2 |
| Registration plate lamp issues | 2 |
| Offside Stop lamp not working |1.2.1b| | 2 |
| Stop lamp remains on when the brakes are released | 2 |
| Offside Front wheel bearing rough when rotated |2.5.A.2| | 2 |
| Nearside Front wheel bearing rough when rotated |2.5.A.2| | 2 |
| Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
| Registration plate issues | 1 |
| Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Front Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Offside Seat belt anchorage prescribed area is inadequately repaired |5.2.6| | 1 |
| Rear Panhard rod has excessive play in a pin/bush |2.4.G.2| | 1 |
| Nearside Outer Anti-roll bar rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Inner Anti-roll bar rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Offside Inner Anti-roll bar rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
| Headlamp not working on main beam |4.1.1 |a| |ii|| | 1 |
| Offside Headlamp not working on dipped beam |4.1.1 |a| |ii|| | 1 |
| Nearside Rear Position lamp not working |4.2.1 |a|| | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Braking system leaking |3.6.A.1| | 1 |
| Offside Rear Tie bar/rod rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Headlamp switch faulty |1.7.1| | 1 |
| Offside Front position lamp|s| not in good working order |function impaired| |1.1.4a| | 1 |
| Offside Front Torsion bar attachment bracket loose |2.4.E.4a| | 1 |
| Nearside Front Torsion bar attachment bracket loose |2.4.E.4a| | 1 |
| Offside Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 1 |
| Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
| Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
| Front Windscreen wiper not operating automatically when switched on |8.2.1b| | 1 |
| Horn not working |1.6.2a| | 1 |
| Nearside Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Front position lamp|s| flickers when tapped lightly by hand |1.1.4c| | 1 |
| Nearside Front Brake hose twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |
| Offside Rear Brake pipe inadequately clipped |3.6.B.1| | 1 |
| rear brakes release unevenly |3.7.B.4| | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Offside Headlamp not working on dipped beam |1.7.5a| | 1 |
| Brake cable has wires broken and is significantly weakened |3.5.1b| | 1 |
| Front brake application uneven | 1 |
| front brakes release unevenly |3.7.B.4| | 1 |
| Service brake: efficiency below requirements |3.7.B.7| | 1 |
| Offside Drag link end ball joint has excessive play |2.2.B.1f| | 1 |
| Nearside Inner Front Upper Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.4.G.2| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |