Most common failures | No# failures |
---|
Parking brake: efficiency below requirements |3.7.B.7| | 5 |
Headlamp aim out of alignment | 4 |
Service brake: efficiency below requirements |3.7.B.7| | 3 |
Nearside Stop lamp not working |1.2.1b| | 2 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Nearside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 2 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 2 |
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits |7.3.D.3| | 2 |
Offside Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Nearside Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear fog lamp not working |1.3.2b| | 1 |
Rear fog lamp tell tale not working |1.3.1b| | 1 |
Nearside Rear coil spring incomplete |2.4.C.1a| | 1 |
Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Registration plate lamp issues | 1 |
Nearside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Nearside Macpherson strut upper support bearing is rough in operation |2.5.B.1b| | 1 |
Nearside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
Exhaust has part of the system excessively deteriorated |7.1.1a| | 1 |
Nearside Rear Body has a sharp edge caused by corrosion |6.1.C.1| | 1 |
Emissions not tested |7.0| | 1 |
Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Rear coil spring incomplete |2.4.C.1a| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Front Bonded suspension unit bonding failed and part of unit is likely to become displaced |2.4.F.2| | 1 |
Nearside Rear Rear position lamp|s| incomplete |1.1.4a| | 1 |
Registration plate issues | 1 |
Nearside Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Offside Steering component mounting prescribed area is excessively corroded |2.2.C.1h| | 1 |
Offside Rear Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front Lower Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Nearside Front Anti-roll bar linkage fractured |2.4.G.1| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
Nearside Front Upper Shock absorber has an excessively worn bush |2.7.4| | 1 |
Offside Front Upper Shock absorber has an excessively worn bush |2.7.4| | 1 |
Offside Front Seat belt affected by an insecure seat fixing |5.2.1b| | 1 |
Centre Rear Statutory seat belt missing |5.1.1| | 1 |
Offside Rear Statutory seat belt missing |5.1.1| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Offside Front Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Windscreen wiper does not clear the windscreen effectively | 1 |
Driver`s seat insecure |6.2.A.1| | 1 |
Nearside Front Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |