Most common failures | No# failures |
---|
Parking brake: efficiency below requirements |3.7.B.7| | 16 |
Service brake: efficiency below requirements |3.7.B.7| | 7 |
Brakes imbalanced across an axle | 6 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 6 |
Headlamp aim out of alignment | 4 |
Offside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 4 |
Brake hose excessively deteriorated | 4 |
Rear parking brake recording little or no effort | 4 |
Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 4 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 3 |
Registration plate lamp issues | 3 |
Rear brake binding | 2 |
Offside Headlamp not working on dipped beam |1.7.5a| | 2 |
Nearside Rear rear brake recording little or no effort |3.7.B.5a| | 2 |
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Windscreen wiper does not clear the windscreen effectively | 2 |
Rear brake application uneven | 2 |
Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 2 |
Horn not working (7.7 (a) (ii)) | 2 |
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Centre Exhaust system not adequately supported |7.1.1| | 1 |
Nearside Rear Brake clevis joint locking device missing |3.5.1l| | 1 |
Fuel pipe leaking excessively or a risk of fire fuel pipe to fuel pump |6.1.3 |b| |ii|| | 1 |
Fuel system component leaking excessively or a risk of fire fuel pump |6.1.3 |b| |ii|| | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Headlamp not working on main beam |1.7.5a| | 1 |
Offside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside front brake recording little or no effort |3.7.B.5a| | 1 |
Offside front brake recording little or no effort |3.7.B.5a| | 1 |
Front Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Offside Direction indicators flashing less than 60 times a minute |1.4.A.2g| | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Offside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
Nearside Side repeater not working |1.4.A.2c| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Position lamp not working |4.2.1 |a|| | 1 |
Offside Headlamp not working on main beam |4.1.1 |a| |ii|| | 1 |
Nearside Rear Wheel bearing so rough it is likely to overheat or break up |5.1.3 |b| |ii|| | 1 |
Offside Front Tie bar/rod attachment bracket/mounting insecure |2.4.G.1| | 1 |
Offside Front Lower Suspension arm attachment bracket/mounting insecure |2.4.G.1| | 1 |
Nearside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
Nearside Rear Fuel pipe leaking |7.2.3| | 1 |
Offside Rear Fuel pipe leaking |7.2.3| | 1 |
Offside Inner Front Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Front Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Upper Suspension component mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Nearside Front Lower Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Lower Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Offside Front Lower Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Lower Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Nearside Rear Lower Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Lower Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Offside Rear Lower Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Lower Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Nearside Rear Upper Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Upper Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Offside Rear Upper Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Upper Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Offside Lower Seat belt anchorage prescribed area is inadequately repaired |5.2.6| | 1 |
Nearside Lower Seat belt anchorage prescribed area is inadequately repaired |5.2.6| | 1 |
Offside Lower Seat belt has a cut which has significantly weakened the webbing |5.2.2a| | 1 |
Nearside Front Steering system has excessive free play detected at the steering wheel |steering rack fitted| |2.2.A.1b| | 1 |
Offside Front Steering system has excessive free play detected at the steering wheel |steering rack fitted| |2.2.A.1b| | 1 |
Brake pipe excessively corroded | 1 |
Offside Lower Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Nearside Front suspension has a suspension lower ball joint securing nut loose |2.5.B.1a| | 1 |
Nearside Lower Front suspension has a suspension lower ball joint securing nut not locked |2.5.B.1a| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake hose damaged | 1 |
Rear Radius arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Stop lamp not working BOTH |1.2.1b| | 1 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering inner A pillar |6.1.A.1| | 1 |
Exhaust emits clearly visible black smoke during acceleration |7.3.A.2c| | 1 |
Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Offside Front Front constant velocity joint is insecure |2.5.C.1b| | 1 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Sub-frame attachment bracket/mounting bolt missing |2.4.G.1| | 1 |
Nearside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Offside Front Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Nearside Inner Rear Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Nearside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Offside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Front brake application uneven | 1 |
Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Suspension component mounting prescribed area is excessively corroded offside rear floor section corroded |2.4.A.3| | 1 |
Seat belt anchorage prescribed area is excessively corroded offside outer sill corroded to excess |5.2.6| | 1 |
Subframe mounting prescribed area is excessively corroded nearside rear sill section |2.4.A.3| | 1 |
Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt offside and nearside front covers |2.2.C.1c| | 1 |
Rear wheel bearing has excessive play nearside rear wheel bearing |2.6.2| | 1 |
Offside Front constant velocity joint gaiter split |2.5.C.1a| | 1 |
Horn not working |1.6.2a| | 1 |
Offside Rear Fluid suspension leaking |2.4.D.2| | 1 |
Nearside Front Seat belt missing (7.1.2 (a)) | 1 |
Offside Front Seat belt missing (7.1.2 (a)) | 1 |
Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) | 1 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Steering system has excessive free play detected at the steering wheel |steering rack fitted| |2.2.A.1b| | 1 |
Rear Sub-frame corroded and seriously weakened |2.4.G.1| | 1 |
Offside Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
Nearside Front Front suspension has a suspension lower ball joint securing nut not locked |2.5.B.1a| | 1 |
Nearside Front Front suspension has a loose unit in the upper support bearing assembly |2.5.B.3b| | 1 |
Nearside Fluid suspension has no suspension movement |2.4.D.5| | 1 |
Nearside Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |
Offside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt |2.2.C.1c| | 1 |
Nearside Front Seat belt retracting mechanism defective (7.1.2 (e)) | 1 |
Offside Front Seat belt retracting mechanism defective (7.1.2 (e)) | 1 |
Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
Nearside Front Lower Front suspension retaining device ineffective |2.5.A.4| | 1 |
Offside Front Lower Front suspension retaining device ineffective |2.5.A.4| | 1 |