>

MOT History from tests of petrol VANDEN PLAS 1300s year 1968

Review the list of common VANDEN PLAS 1300 failures below or to perform a specific mot history check on your VANDEN PLAS then use our popular KnowYourCar service

mot history
Pass percent:80.73%
(The average a petrol VANDEN PLAS 1300 year 1968 passes without issue)
Based on:109 MOT Tests
Most common failuresNo# failures
Parking brake: efficiency below requirements |3.7.B.7|4
Registration plate lamp issues4
Brake pipe excessively corroded3
Nearside Front position lamp|s| not working |1.1.A.3b|3
Service brake: efficiency below requirements |3.7.B.7|2
Rear Exhaust system not adequately supported |7.1.1|2
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2|2
Horn not working |1.6.2a|2
Offside Front Headlamp not working on dipped beam |1.7.5a|2
Fuel system component leaking |7.2.3|2
Headlamp aim out of alignment2
Nearside front brake binding |3.7.B.1|2
Offside rear brake recording little or no effort |3.7.B.5a|2
Rear parking brake recording little or no effort2
Offside Front drive shaft coupling is excessively worn |2.5.C.1c|1
Indicator tell tale inoperative |1.4.A.2a|1
Nearside Front constant velocity joint gaiter split |2.5.C.1a|1
Offside Front Tie bar/rod locating pin insecure |2.4.G.3a|1
Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2|1
Nearside Front Track rod end ball joint has excessive play |2.2.B.1f|1
Nearside rear brake recording little or no effort |3.7.B.5a|1
Offside Rear rear brake recording little or no effort |3.7.B.5a|1
Nearside Front Fluid suspension has no suspension movement |2.4.D.5|1
Nearside Headlamp not working on dipped beam |1.7.5a|1
Nearside Headlamp excessively deteriorated so that the light output is severely reduced |1.7.5a|1
Nearside Headlamp does not operate immediately when selected on dipped beam |1.7.4a|1
Offside Headlamp does not operate immediately when selected on dipped beam |1.7.4a|1
Headlamp switch faulty |1.7.1|1
Nearside Front Upper Suspension component mounting prescribed area is excessively corroded |2.4.A.3|1
Centre Exhaust system not adequately supported |7.1.1|1
Nearside Brake cable has wires broken and is significantly weakened |3.5.1b|1
Brakes imbalanced across an axle1
Rear Mechanical brake component has restricted free movement1
Offside Front Fluid suspension has no suspension movement |2.4.D.5|1
Offside Rear Fluid suspension has no suspension movement |2.4.D.5|1
Offside Outer Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3|1
Windscreen wiper does not clear the windscreen effectively1
Nearside Front Sub-frame attachment bracket/mounting insecure |2.4.G.1|1
Nearside Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a|1
Nearside Front Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a|1
Offside Front Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a|1
Offside Front Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a|1
Offside Side repeater not working |1.4.A.2c|1
Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3|1
Rear brake binding1
Offside Headlamp not working on dipped beam |1.7.5a|1
Offside front brake binding |3.7.B.1|1
Brake hose excessively deteriorated1
Offside Front Steering rack gaiter insecure |2.2.D.2d|1
Offside Rear Upper Fuel hose leaking |7.2.3|1
Rear Sub-frame corroded and seriously weakened |2.4.G.1|1
Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6|1
Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6|1
Offside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3|1
Nearside Front Lower Subframe mounting prescribed area is excessively corroded |2.4.A.3|1
Nearside Front Upper Subframe mounting prescribed area is excessively corroded |2.4.A.3|1
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3|1
Front brake application uneven1
Front brake disc in such a condition that it is seriously weakened1
Nearside Front Headlamp not working on dipped beam |1.7.5a|1
Offside Front Direction indicator not working |1.4.A.2c|1
Exhaust has a major leak of exhaust gases |7.1.2|1
Nearside Rear Shock absorber has negligible damping effect |2.7.5|1
Offside Rear Shock absorber has negligible damping effect |2.7.5|1
Offside Rear Braking system leaking |3.6.A.1|1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Find us on Facebook

© KnowYourCar™ 2019. All rights reserved
Except where otherwise noted, content on our MOT statistics pages are licensed under a Creative Commons Attribution 4.0 International license.
You are free to redistribute the material in any medium or format as long as credit is given to KnowYourCar

WARNING: We have placed hidden watermarks in our data. We will take action against our data being used outside of these terms.

MOT Data licensed under the Open Government Licence v3.0

By using our site you are agreeing to our terms and conditions
Terms & Conditions  Privacy Policy