Most common failures | No# failures |
---|
Headlamp aim out of alignment | 29 |
Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 9 |
Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 9 |
Horn not working |1.7.3a| | 6 |
Steering headbearing has excessive free play |2.2.2| | 6 |
Headlamp at least one does not illuminate on main beam |1.2.2a|ii|| | 5 |
Headlamp at least one does not illuminate on dipped beam |1.2.2a|i|| | 5 |
Rear reflector on motorcycle missing |1.4.1| | 4 |
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 4 |
Front Brake lever insecure |3.1.2a| | 3 |
Front Brake lever has inadequate reserve travel |3.1.3b| | 3 |
Rear Rear reflector on motorcycle missing |1.4.1| | 3 |
Stop lamp affected by the operation of another lamp |1.3.2| | 3 |
Roller brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.A2b| | 3 |
Windscreen wiper does not clear the windscreen effectively | 3 |
Horn missing |1.7.1| | 2 |
Nearside Front shock absorber seal failed and leaking oil |2.3.3| | 2 |
Riders seat insecure |6.2.1a| | 2 |
Wheel alignment incorrect which adversely affects the handling |2.5.1| | 2 |
Rear position lamp adversely affected by the operation of another lamp |1.1.3b| | 2 |
Rear Floor brake test indicates a binding brake |3.3.C2c| | 2 |
Locking device|s| not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 2 |
Offside Front shock absorber seal failed and leaking oil |2.3.3| | 2 |
Drive chain excessively tight |6.2.1d| | 2 |
Rear Footrest missing |6.2.1a| | 2 |
Stop lamp remains on when the brake is released |1.3.1e| | 2 |
Drive chain excessively loose |6.2.1d| | 2 |
Front wheel bearings are excessively rough |2.3.5b| | 2 |
Handlebar mounting clamp bolt loose |2.1.1a| | 2 |
Rear brake binding | 2 |
Offside front brake binding |3.7.B.1| | 2 |
Steering system has excessive free play detected at the steering wheel |steering rack fitted| |2.2.A.1b| | 2 |
Brake hose has insufficient room to move | 2 |
Registration plate lamp issues | 2 |
Horn not working |1.6.2a| | 2 |
Front Brake drum|s| securing bolt|s| loose |3.2.A1g| | 1 |
Nearside Rear Rear shock absorber insecurely mounted |2.4.A.3b| | 1 |
Rear Brake linkage has abnormal movement due to maladjustment |3.2.A1i| | 1 |
Brake lever has inadequate reserve travel |3.1.3b| | 1 |
Rear Front mudguard insecure |2.3.7| | 1 |
Fuel hose leaking |7.2.1a| | 1 |
Offside Front Lower Suspension component pin or bush excessively worn |5.3.4 |a| |i|| | 1 |
Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
Brakes imbalanced across an axle | 1 |
Rear Wheel alignment incorrect which adversely affects the handling |2.5.1| | 1 |
Front Brake back plate|s| insecure |3.2.A1j| | 1 |
Rear wheel rotation likely to be impeded |6.2.1b| | 1 |
Brake pedal has inadequate reserve travel |3.1.3b| | 1 |
All position lamps do not illuminate immediately when switched on |1.1.3a| | 1 |
Stop lamp does not emit a steady light |1.3.1b| | 1 |
Rear position lamp incorrect colour |1.1.2b| | 1 |
Front Floor brake test indicates a binding brake |3.3.C2c| | 1 |
Central Front Horn not working (7.7 (a) (ii)) | 1 |
Rear suspension bearing has excessive free play |2.4.A2a|i|| | 1 |
Front Roller brake test indicates excessive fluctuation of brake effort |3.3.A1d| | 1 |
Brake lever insecure |3.1.2a| | 1 |
Fuel system component leaking carb |7.2.1a| | 1 |
Rear suspension component loose |2.4.A.1a| | 1 |
An item not tested |Manual| | 1 |
Front suspension has excessive stiffness in the suspension movement. |2.3.6b| | 1 |
Rear Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 1 |
Rear Rear reflector on motorcycle does not reflect squarely to the rear |1.4.1| | 1 |
Wheel spoke excessively loose loose spoke
|4.2.1b| | 1 |
Front Front suspension has excessive stiffness in the suspension movement. |2.3.6b| | 1 |
Nearside Lower Fuel hose leaking |7.2.1a| | 1 |
Offside Front Brake reaction bracket securing bolt|s| loose |3.2.A1j| | 1 |
Rear Stop lamp remains on when the brake is released |1.3.1e| | 1 |
Offside Handlebar handgrip not secure to handlebars. |2.1.1c| | 1 |
Steering movement excessively `notchy` with the wheel raised |2.2.1b| | 1 |
Offside Fuel hose leaking |7.2.1a| | 1 |
Rear Stop lamp insecure |1.3.3b| | 1 |
Headlamp aim beam image kick up to the offside |1.6| | 1 |
Nearside Front Front suspension has a suspension upper ball joint securing nut loose |2.5.B.1a| | 1 |
Nearside Front Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Rear Locking devices not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 1 |
Rear wheel spindle securing nut|s| loose |2.4.A.2b| | 1 |
Rear wheel bearings have excessive free play |2.4.A.2c| | 1 |
Front Horn missing |1.7.1| | 1 |
Wheel alignment incorrect which adversely affects the steering |2.5.1| | 1 |
Rear Drive chain worn to excess |6.2.1e| | 1 |
Nearside Front Front shock absorber seal failed and leaking oil |2.3.3| | 1 |
Front Brake lever is inoperative |3.1.3c| | 1 |
Steering movement excessively stiff with the wheel raised |2.2.1b| | 1 |
Front Front wheel bearings have excessive free play |2.3.5b| | 1 |
Floor brake test No brake control achieves an efficiency of 30%. |3.3.C1a| | 1 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 1 |
Rear Stop lamp not working |1.2.1b| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Steering headbearing excessively stiff or notchy |2.2.2 |f| |i|| | 1 |
Stop lamp remains on when the brakes are released | 1 |
Rear Position lamp not working |4.2.1 |a|| | 1 |
Nearside Rear Brake lining|s| insecure |3.5.1g| | 1 |
Offside Rear Brake lining|s| insecure |3.5.1g| | 1 |
Lower Steering column movement between the shaft and steering wheel |2.1.2b| | 1 |
Parking brake: efficiency below requirements |3.7.B.7| | 1 |
Front Brake pipe inadequately clipped |3.6.B.1| | 1 |
Parking brake: efficiency below requirements |3.7.C.1b| | 1 |
Nearside Front front brake recording little or no effort |3.7.B.5a| | 1 |
Offside Front front brake recording little or no effort |3.7.B.5a| | 1 |
Service brake: efficiency below requirements |3.7.B.7| | 1 |
Offside Rear shock absorber insecurely mounted |2.4.A.3b| | 1 |
Offside Rear Direction indicators not working |1.5.1c| | 1 |
Offside Front Direction indicators not working |1.5.1c| | 1 |
Brake lever mounting cracked |3.1.2c| | 1 |
Front Headlamp aim headlamp deteriorated and function impaired |1.2.3a| | 1 |
Nearside Front Handlebar handgrip not secure to handlebars. |2.1.1c| | 1 |
Steering movement excessively `notchy` with the weight on the lower bearing |2.2.1a| | 1 |
Rear Wheel spoke excessively loose |4.2.1b| | 1 |
Fuel pipe leaking |7.2.1a| | 1 |
Locking devices not correctly fitted which may make the motor bicycle dangerous to ride |6.2.1h| | 1 |
Front Brake locking device missing |3.2.A1e| | 1 |
Front Brake lever has inadequate reserve travel Front Brake inadequate reserve travel-and no adjuster fitted |3.1.3b| | 1 |
Rear Rear shock absorber has inadequate damping effect. |2.4.A.3b| | 1 |
Rear Rear wheel bearings have excessive free play |2.4.A.2c| | 1 |
Upper Steering headbearing has excessive free play |2.2.2| | 1 |
Steering control fouling between components which interferes with the free movement of the steering |2.1.2a| | 1 |
Rear wheel has a loose wheel nut|s| |4.2.3a| | 1 |
Front passenger door cannot be opened from inside the vehicle |6.2.B.1b| | 1 |
Front passenger door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
Front brake application uneven | 1 |
Nearside front brake binding |3.7.B.1| | 1 |
Nearside Front All position lamps not working |1.1.A.3b| | 1 |
Centre Exhaust has a part missing |7.1.1a| | 1 |
Rear Wheel alignment incorrect which adversely affects the steering |2.5.1| | 1 |
Fuel tank leaking |7.2.1a| | 1 |
Plate brake test The less effective brake control does not achieve an efficiency of 25%. |3.3.B2b| | 1 |
Offside Front wheel bearing has excessive play |2.5.A.3c| | 1 |
Driver`s door cannot be opened from outside the vehicle |6.2.B.1b| | 1 |
Steering column flexible coupling has excessive play |2.1.5| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake hose excessively deteriorated | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Headlamp not working on main beam |1.7.5a| | 1 |
Fuel cap/sealing device sealing washer deteriorated |7.2.4c| | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Nearside Rear front brake binding |3.7.B.1| | 1 |
Nearside Rear An item not tested |Manual| | 1 |
Nearside Rear Brake performance not tested |3.7.A.1| | 1 |
Nearside Rear Chain guard fouling another component |6.2.1c| | 1 |
Rear position lamp adversely affected by the operation of the horn |1.1.3b| | 1 |
Headlamp main beam affected by the operation of the horn |1.2.2c| | 1 |
Headlamp dipped beam affected by the operation of the horn |1.2.2c| | 1 |
Horn not loud enough to be heard by another road user |1.7.3a| | 1 |
Nearside Steering lock stop ineffective |2.1.3| | 1 |
Offside Steering lock stop ineffective |2.1.3| | 1 |
Front position lamp does not illuminate immediately when switched on |1.1.3a| | 1 |
Rear wheel insecure |4.2.3b| | 1 |
Rear suspension fouling which affects the movement of the rear suspension |2.4.A.3a| | 1 |
Rear Brake component is severely distorted |3.1.5| | 1 |