Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 8 |
Headlamp aim out of alignment | 6 |
Service brake: efficiency below requirements |3.7.B.7| | 4 |
Exhaust emissions carbon monoxide content excessive |7.3.B.1a| | 4 |
Rear parking brake recording little or no effort | 3 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 3 |
Nearside Headlamp not working on main beam |1.7.5a| | 3 |
Parking brake: efficiency below requirements |3.7.B.7| | 3 |
Rear Stop lamp does not illuminate immediately a brake applies |1.3.1a| | 3 |
Registration plate lamp issues | 3 |
Direction indicators flashing less than 60 times a minute |1.4.A.2g| | 3 |
Rear Exhaust system not adequately supported |7.1.1| | 2 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 2 |
Front brake application uneven | 2 |
Direction indicators flashing less than 60 times a minute |1.5.1c| | 2 |
Stop lamp remains on when the brakes are released | 2 |
Rear brake binding | 2 |
Rear Decelerometer brake test indicates a binding brake |3.3.E1d| | 2 |
Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
Nearside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Nearside Front Anti-roll bar attachment bracket/mounting insecure |2.4.G.1| | 1 |
Offside Front Anti-roll bar attachment bracket/mounting insecure |2.4.G.1| | 1 |
Nearside Front suspension has a suspension lower ball joint securing nut not locked |2.5.B.1a| | 1 |
Offside Front suspension has a suspension lower ball joint securing nut not locked |2.5.B.1a| | 1 |
Nearside Rear Suspension arm locating pin locking device not properly locked |2.4.G.3b| | 1 |
Offside Rear Suspension arm locating pin locking device not properly locked |2.4.G.3b| | 1 |
Nearside Indicator tell tale inoperative |1.4.A.2a| | 1 |
Nearside Rear Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Offside Rear Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Offside Front Front position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Nearside Rear Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
Offside Rear Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
Offside Rear Rear fog lamp adversely affected by the operation of another lamp |1.3.2f| | 1 |
Nearside Front Lower Suspension arm locating pin insecure inner bolt loose |2.4.G.3a| | 1 |
Nearside Rear Shock absorber insecure lower bush/fixing loose/worn |2.7.2b| | 1 |
Offside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Lower Steering column universal joint insecure on top of rack loose on splines |2.1.5| | 1 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Nearside Front Headlamp missing |1.7.3| | 1 |
Horn not working |1.6.2a| | 1 |
Nearside Front Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
Offside Front Seat belt insecurely fixed to the vehicles structure |5.2.1a| | 1 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 1 |
Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Nearside Rear Footrest missing |6.2.1a| | 1 |
Front Direction indicators affected by the operation of another lamp |1.5.1c| | 1 |
Rear Direction indicators affected by the operation of another lamp |1.5.1c| | 1 |
Front Direction indicators flashing less than 60 times a minute |1.5.1c| | 1 |
Rear Direction indicators flashing less than 60 times a minute |1.5.1c| | 1 |
Brake pipe excessively corroded | 1 |
Windscreen wiper blade insecure | 1 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Front Wheel has an excessively distorted bead rim. |4.2.2| | 1 |
Parking brake: efficiency below requirements |3.7.C.1b| | 1 |
Nearside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Front Sub-frame attachment bracket/mounting corroded and its strength is seriously reduced |2.4.G.1| | 1 |
Fuel tank leaking |7.2.3| | 1 |
Rear Rear position lamp does not illuminate immediately when it is switched on |1.1.3a| | 1 |
Registration plate issues | 1 |
Stop lamp not working |1.2.1b| | 1 |
Rear position lamp|s| not working |1.1.A.3b| | 1 |
Offside Rear Trailing arm attachment bracket/mounting corroded and its strength is seriously reduced |2.4.G.1| | 1 |
Offside Front Brake hose leaking |3.6.A.1| | 1 |
Nearside Front Brake pipe inadequately supported |3.6.B.1| | 1 |
Offside Front Brake pipe inadequately supported |3.6.B.1| | 1 |
Exhaust has a part missing |7.1.1a| | 1 |
Exhaust mounting missing |7.1.1b| | 1 |
Horn missing |1.7.1| | 1 |
Rear Wheel has an excessively distorted bead rim. |4.2.2| | 1 |
Footrest insecure |6.2.1a| | 1 |
Offside Indicator tell tale inoperative |1.4.A.2a| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Driver`s seat fore and aft adjustment mechanism not functioning as intended. |6.2.A.3| | 1 |
Nearside Direction indicators flashing less than 60 times a minute front and rear |1.4.A.2g| | 1 |
Nearside Front engine mounting bracket insecure and likely to fail |6.1.D.1b| | 1 |
Nearside Front Lower Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Nearside Rear Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Front Shock absorber has an excessively worn shock absorber pivot |2.7.4| | 1 |
Mechanical brake component has restricted free movement | 1 |
Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
Offside Rear Direction indicators not working |1.5.1c| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Throttle operating incorrectly |6.2.1f| | 1 |
Stop lamp remains on when the brake is released |1.3.1e| | 1 |
Offside Lower Suspension arm has excessive play in a ball joint |2.4.G.2| | 1 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Brakes imbalanced across an axle | 1 |