| Most common failures | No# failures |
|---|
| Headlamp aim out of alignment | 4 |
| Rear parking brake recording little or no effort | 2 |
| Hazard warning lamps not flashing in phase, with ignition on |1.4.B.1f| | 1 |
| Hazard warning lamps not flashing in phase, with ignition off |1.4.B.1f| | 1 |
| Horn not working |1.6.2a| | 1 |
| Rear Exhaust system not adequately supported |7.1.1| | 1 |
| Parking brake: efficiency below requirements |3.7.B.7| | 1 |
| Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner wheel arch at front of sill (6.2.2 (d) (i)) | 1 |
| Nearside Front Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i)) | 1 |
| Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting chassis (6.2.2 (d) (i)) | 1 |
| Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill /inner wheel arch (6.2.2 (d) (i)) | 1 |
| Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill/inner wheel arch (6.2.2 (d) (i)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
| Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill section outer (5.3.6 (a) (i)) | 1 |
| Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill section (5.3.6 (a) (i)) | 1 |
| Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis out rigger (5.3.6 (a) (i)) | 1 |
| Nearside Outer Dipswitch operation does not extinguish all main beam headlamps leaving at least one pair of dipped beam headlamps |1.7.4b| | 1 |
| Nearside Outer Dipswitch operation does not deflect all main beam headlamps to make them dipped beams |1.7.4b| | 1 |
| Driver`s seat cannot be secured in the upright position. |6.2.A.2| | 1 |
| Windscreen wiper does not clear the windscreen effectively | 1 |
| Fuel cap/sealing device missing |7.2.4a| | 1 |
| Offside Rear Direction indicator not working |1.4.A.2c| | 1 |
| Nearside Headlamp not working on main beam |1.7.5a| | 1 |
| Headlamp adversely affected by the operation of another lamp |1.7.5c| | 1 |
| Fuel cap/sealing device sealing washer missing |7.2.4c| | 1 |
| Headlamp switch faulty |1.7.1| | 1 |
| Offside Stop lamp not working |1.2.1b| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |