| Most common failures | No# failures |
|---|
| Windscreen wiper does not clear the windscreen effectively | 6 |
| Headlamp aim out of alignment | 5 |
| Rear brake binding | 4 |
| Nearside Rear Upper Outline marker lamp not working (4.2.1 (a) (ii)) | 2 |
| Offside Front Service brake excessively binding (1.2.1 (f)) | 2 |
| Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 2 |
| Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
| Front brake disc in such a condition that it is seriously weakened | 1 |
| Electrical wiring insecure and in contact with sharp edges Wire from positive battery terminal (4.11 (a) (ii)) | 1 |
| Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Rear Suspension spring mounting prescribed area is excessively corroded front mount |2.4.A.3| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded front mount |2.4.A.3| | 1 |
| Nearside Windscreen wiper blade deteriorated |8.2.2| | 1 |
| Offside Windscreen wiper blade deteriorated |8.2.2| | 1 |
| Offside Front position lamp|s| not working |1.1.A.3b| | 1 |
| Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
| Horn not working |1.6.2a| | 1 |
| Nearside Rear Service brake excessively binding (1.2.1 (f)) | 1 |
| Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i)) | 1 |
| Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b)) | 1 |
| Nearside Integral body structure is deformed and structural rigidity is significantly reduced inner sill, middle and rear (6.1.1 (a) (i)) | 1 |
| Offside Integral body structure is deformed and structural rigidity is significantly reduced inner sill, middle and rear (6.1.1 (a) (i)) | 1 |
| Offside Rear Parking brake inoperative on one side (1.4.1 (a)) | 1 |
| Front Exhaust has a major leak of exhaust gases (6.1.2 (a)) | 1 |
| Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
| Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) | 1 |
| Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) | 1 |
| Service brake efficiency below requirements (1.2.2 (a) (i)) | 1 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Offside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Service brake: efficiency below requirements |3.7.C.1a| | 1 |
| Registration plate lamp issues | 1 |
| Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i)) | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |