Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 13 |
Headlamp aim out of alignment | 12 |
Rear brake binding | 6 |
Brakes imbalanced across an axle | 6 |
Parking brake: efficiency below requirements |3.7.B.7| | 4 |
Service brake: efficiency below requirements |3.7.B.7| | 4 |
Rear brake application uneven | 4 |
Rear parking brake recording little or no effort | 3 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 3 |
Nearside Headlamp aim beam image kick up to the offside |1.8| | 3 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 3 |
Rear fog lamp not working |1.3.2b| | 2 |
Nearside Front Front wheel bearing rough when rotated |2.5.A.2| | 2 |
Registration plate lamp issues | 2 |
Nearside Stop lamp not working |1.2.1b| | 2 |
Rear fog lamp not working (4.5.1 (a) (ii)) | 2 |
Service brake efficiency below requirements (1.2.2 (a) (i)) | 2 |
Nearside front brake binding |3.7.B.1| | 2 |
Mechanical brake component has restricted free movement | 2 |
Offside Front Shock absorbers has a serious fluid leak | 2 |
Front brake application uneven | 2 |
Offside front brake binding |3.7.B.1| | 2 |
Brake pipe excessively corroded | 1 |
Nearside Rear Rear position lamp|s| not working marker |1.1.A.3b| | 1 |
Driver`s seat insecure |6.2.A.1| | 1 |
Passenger`s seat insecure |6.2.A.1| | 1 |
Nearside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Front Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill and jacking point |6.1.B.2| | 1 |
Position lamp not working All (4.2.1 (a) (ii)) | 1 |
Headlamp not working on dipped beam Both (4.1.1 (a) (ii)) | 1 |
Headlamp not working on main beam Both (4.1.1 (a) (ii)) | 1 |
Offside Rear fog lamp not working (4.5.1 (a) (ii)) | 1 |
Rear fog lamp tell-tale not working (4.9.1 (a) (ii)) | 1 |
Headlamp aim not tested (4.1.2 (b)) | 1 |
Subframe mounting prescribed area excessively corroded significantly reducing structural strength OSF inner wheelarch and outrigger (5.3.6 (a) (i)) | 1 |
Subframe mounting prescribed area excessively corroded significantly reducing structural strength NSF outrigger (5.3.6 (a) (i)) | 1 |
Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i)) | 1 |
Front Headlamp aim beam image kick up to the offside |1.8| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Horn not working |1.6.2a| | 1 |
Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
Offside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
Fuel tank leaking |7.2.3| | 1 |
Nearside Front Lower Brake hose bulging under pressure |3.6.B.3| | 1 |
Nearside Front Lower Brake hose twisted |found during steering lock to lock check| |2.2.D.2b| | 1 |
Brake load sensing valve seized |3.6.E.3| | 1 |
Rear fog lamp not working |4.5.1 |a| |ii|| | 1 |
Headlamp aim projected beam image is obviously incorrect nearside and offside headlamp beam image kick up to offside |4.1.2 |c|| | 1 |
Service brake efficiency below requirements |1.2.2 |a| |i|| | 1 |
Parking brake efficiency below requirements |1.4.2 |a| |i|| | 1 |
Headlamp aim projected beam image is obviously incorrect Both headlamps kick-up to offside (4.1.2 (c)) | 1 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Nearside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Rear Position lamp not working (4.2.1 (a) (ii)) | 1 |
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Offside Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength in arch (5.3.6 (a) (i)) | 1 |
Headlamp aim beam image kick up to the offside nearside and offside headlamp |1.8| | 1 |
Subframe mounting prescribed area is excessively corroded offside front chassis/jacking point |2.4.A.3| | 1 |
rear brake recording little or no effort nearside |3.7.B.5a| | 1 |
Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement |7.2.4b| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Front Exhaust has a major leak of exhaust gases |6.1.2 |a|| | 1 |
Horn not working |7.7 |a| |ii|| | 1 |
Stop lamp(s) all not working (4.3.1 (a) (iii)) | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` wipers |8.3.1e| | 1 |
Offside Front Inner Suspension component mounting prescribed area excessively damaged significantly reducing structural strength arch behind brake pipe (5.3.6 (a) (i)) | 1 |
Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i)) | 1 |
Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch x2 (5.3.6 (a) (i)) | 1 |
Rear Mechanical brake component has restricted free movement | 1 |
Front brake disc in such a condition that it is seriously weakened | 1 |
Nearside An item not tested |Manual| | 1 |
Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii)) | 1 |
Nearside Rear Position lamp adversely affected by the operation of another lamp affected by fog light (4.2.3 (c)) | 1 |
Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i)) | 1 |
Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) | 1 |
Nearside Integral body structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired (6.2.2 (d) (ii)) | 1 |
Offside Integral body structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired (6.2.2 (d) (ii)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mount (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mount (5.3.6 (a) (i)) | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Offside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch |5.3.6 |a| |i|| | 1 |
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch |5.3.6 |a| |i|| | 1 |
Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced |6.1.1 |c| |i|| | 1 |
Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor |7.1.1 |a| |i|| | 1 |
Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc |2.5.C.1a| | 1 |
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii)) | 1 |
Nearside Headlamp insecure |1.7.3| | 1 |
Horn not loud enough to be heard by another road user |1.6.2b| | 1 |
Offside Front front brake binding |3.7.B.1| | 1 |
Offside Front Headlamp aim not tested |1.8.A.1c| | 1 |
Offside Front Headlamp not working on dipped beam |1.7.5a| | 1 |
Offside Front Headlamp insecure |4.1.1 |c|| | 1 |
Front Headlamp levelling device inoperative |4.1.5 |a|| | 1 |
Nearside Rear Service brake lagging in operation |1.2.1 |d|| | 1 |
Offside Headlamp aim aimed so that it dazzles other road users |1.8.A.1a| | 1 |
rear brakes release unevenly |3.7.B.4| | 1 |
Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
front brakes release unevenly |3.7.B.4| | 1 |
front brake juddering severely |3.7.A.2b| | 1 |
Nearside Rear rear brake recording little or no effort |3.7.B.5a| | 1 |
Nearside rear brakes release unevenly |3.7.B.4| | 1 |
Nearside Rear An item not tested |Manual| | 1 |