Most common failures | No# failures |
---|
Windscreen wiper does not clear the windscreen effectively | 21 |
Registration plate lamp issues | 9 |
Brake pipe excessively corroded | 6 |
Headlamp aim out of alignment | 4 |
Nearside Rear coil spring broken |2.4.C.1a| | 3 |
Offside Rear Coil spring fractured or broken (5.3.1 (b) (i)) | 3 |
Offside Rear position lamp|s| not working |1.1.A.3b| | 3 |
Offside Rear coil spring broken |2.4.C.1a| | 3 |
Offside Headlamp not working on dipped beam |1.7.5a| | 3 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 3 |
Offside Front position lamp|s| not working |1.1.A.3b| | 3 |
Registration plate issues | 3 |
Nearside Headlamp not working on dipped beam |1.7.5a| | 3 |
Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i)) | 2 |
Nearside Front Position lamp not working (4.2.1 (a) (ii)) | 2 |
Rear Position lamp not working (4.2.1 (a) (ii)) | 2 |
Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Front brake disc in such a condition that it is seriously weakened | 2 |
Brakes imbalanced across an axle | 1 |
Front Service brake excessively fluctuating |1.2.1 |e|| | 1 |
Rear Exhaust has a major leak of exhaust gases |6.1.2 |a|| | 1 |
Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i)) | 1 |
Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Axle mount (5.3.6 (a) (ii)) | 1 |
Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Axle mount (5.3.6 (a) (ii)) | 1 |
Nearside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Wheel arch (5.3.6 (a) (i)) | 1 |
Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Wheel arch (5.3.6 (a) (i)) | 1 |
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill/boot floor area (5.3.6 (a) (i)) | 1 |
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) | 1 |
Nearside Rear Parking brake inoperative on one side (1.4.1 (a)) | 1 |
Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected both inner and outer sills (5.3.6 (a) (ii)) | 1 |
Windscreen has damage | 1 |
Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i)) | 1 |
Offside Front Brake pipe leaking to flexie |3.6.A.1| | 1 |
Nearside Stop lamp not working |1.2.1b| | 1 |
Nearside Rear Rear position lamp|s| excessively damaged so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b)) | 1 |
Offside Front Position lamp not working |4.2.1 |a|| | 1 |
Nearside Front Anti-roll bar synthetic bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Rear Exhaust has a major leak of exhaust gases |7.1.2| | 1 |
Service brake excessively binding Both front (1.2.1 (f)) | 1 |
Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a)) | 1 |
Offside Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
Nearside Front Position lamp not working |4.2.1 |a|| | 1 |
Front Position lamp not working Both (4.2.1 (a) (ii)) | 1 |
Nearside Rear position lamp|s| not working |1.1.A.3b| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Offside Rear Coil spring fractured or broken |5.3.1 |b| |i|| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill distorted and (5.3.6 (a) (i)) | 1 |
Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill distorted and (5.3.6 (a) (i)) | 1 |
Nearside Rear Lower Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner wheelarch (5.3.6 (a) (i)) | 1 |
Offside Rear Lower Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner wheelarch (5.3.6 (a) (i)) | 1 |
Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i)) | 1 |
Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i)) | 1 |
Rear brake disc in such a condition that it is seriously weakened | 1 |
Offside Rear Service brake excessively fluctuating (1.2.1 (e)) | 1 |
Offside Rear Parking brake inoperative on one side grabbing on excess (1.4.1 (a)) | 1 |
Parking brake efficiency below requirements (1.4.2 (a) (i)) | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded sill end |2.4.A.3| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded sill end |2.4.A.3| | 1 |
Offside Front Body has a sharp edge caused by damage |6.1.C.1| | 1 |
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Nearside Rear Parking brake mechanism/associated mounting prescribed area is excessively corroded back plate (1.1.21 (e) (i)) | 1 |
Offside Rear Parking brake mechanism/associated mounting prescribed area is excessively corroded back plate (1.1.21 (e) (i)) | 1 |
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing area (5.3.6 (a) (i)) | 1 |
Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c)) | 1 |
Offside Rear Brake drum back plate insecure and coroded (1.1.14 (d)) | 1 |
Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i)) | 1 |
Nearside Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
Offside Headlamp aim projected beam image is obviously incorrect |4.1.2 |c|| | 1 |
Nearside Stop lamp|s| not working |4.3.1 |a| |ii|| | 1 |
Nearside Front Front position lamp|s| not working |1.1.A.3b| | 1 |
Rear brake binding | 1 |
Nearside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Offside Front Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Nearside Rear Brake pipe leaking on a hydraulic braking system |1.1.11 |b| |ii|| | 1 |
Nearside Outer Front Brake lining|s| less than 1.5 mm thick |3.5.1g| | 1 |
Headlamp aim not tested |1.8.A.1c| | 1 |
Nearside Position lamp not working (4.2.1 (a) (ii)) | 1 |
Offside Front Position lamp not working (4.2.1 (a) (ii)) | 1 |
Exhaust has a major leak of exhaust gases Rear silencer |7.1.2| | 1 |
Offside front brake binding |3.7.B.1| | 1 |
Offside Rear Service brake excessively binding |1.2.1 |f|| | 1 |