MOT History from tests of petrol TOYOTA MR2s year 1984

Review the list of common TOYOTA MR2 failures below or to perform a specific mot history check on your TOYOTA then use our popular KnowYourCar service

mot history

Pass percent:53.33%

(The average a petrol TOYOTA MR2 year 1984 passes without issue)

Based on:15 MOT Tests

Most common failures	No# failures
Parking brake lever has no reserve travel \|3.1.6b\|	4
Rear parking brake recording little or no effort	3
Offside Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	2
Headlamp aim out of alignment	2
Front Front position lamp\|s\| incorrect colour \|1.1.A.3e\|	1
Parking brake: efficiency below requirements \|3.7.C.1b\|	1
Windscreen wiper not working from switch (3.4 (a))	1
Registration plate issues	1
Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))	1
Front position lamp\|s\| incorrect colour \|1.1.A.3e\|	1
Nearside Front Anti-roll bar linkage has excessive play in a ball joint \|2.4.G.2\|	1
Nearside Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Horn not working \|1.6.2a\|	1
Offside Front Body has a sharp edge caused by corrosion \|6.1.C.1\|	1
Offside Rear Shock absorber has an excessively worn shock absorber pivot \|2.7.4\|	1
Nearside Rear Body has a sharp edge caused by corrosion \|6.1.C.1\|	1
Offside Rear Body has a sharp edge caused by corrosion \|6.1.C.1\|	1
Offside Rear Rear wheel bearing has excessive play \|2.6.2\|	1
Nearside Front Steering system has excessive free play detected at the steering wheel \|steering rack fitted\| \|2.2.A.1b\|	1
Nearside Side repeater not working \|1.4.A.2c\|	1
Nearside Front Hazard warning lamps not flashing in phase, with ignition on \|1.4.B.1f\|	1
Service brake: efficiency below requirements \|3.7.B.7\|	1
Nearside Front position lamp\|s\| incorrect colour \|1.1.A.3e\|	1
Offside Front position lamp\|s\| incorrect colour \|1.1.A.3e\|	1
Nearside Stop lamp not working \|1.2.1b\|	1
Offside Rear Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Nearside Rear Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Parking brake: efficiency below requirements \|3.7.B.7\|	1
Brakes imbalanced across an axle	1

We get to these numbers by trawling through over 1 billion MOT test results since 2004 and crunched the numbers. We remove anything to do with Tyres, as they are model independent and group together common non-model specific issues. We are trying to get to a picture of what models have what issues.

Please note: We take the data from the DVSA. This data is raw and can contain typos and spelling mistakes that garages may have entered while recording a MOT result. Specifically miss-match on names of models and makes. We are constantly cleaning the data so bear with the odd issue.

Got suggestions? We’re improving this section all the time. If you have any suggestions, please let us know.

Most common failures	No# failures
Parking brake lever has no reserve travel \|3.1.6b\|	4
Rear parking brake recording little or no effort	3
Offside Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	2
Headlamp aim out of alignment	2
Front Front position lamp\|s\| incorrect colour \|1.1.A.3e\|	1
Parking brake: efficiency below requirements \|3.7.C.1b\|	1
Windscreen wiper not working from switch (3.4 (a))	1
Registration plate issues	1
Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))	1
Front position lamp\|s\| incorrect colour \|1.1.A.3e\|	1
Nearside Front Anti-roll bar linkage has excessive play in a ball joint \|2.4.G.2\|	1
Nearside Front Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Horn not working \|1.6.2a\|	1
Offside Front Body has a sharp edge caused by corrosion \|6.1.C.1\|	1
Offside Rear Shock absorber has an excessively worn shock absorber pivot \|2.7.4\|	1
Nearside Rear Body has a sharp edge caused by corrosion \|6.1.C.1\|	1
Offside Rear Body has a sharp edge caused by corrosion \|6.1.C.1\|	1
Offside Rear Rear wheel bearing has excessive play \|2.6.2\|	1
Nearside Front Steering system has excessive free play detected at the steering wheel \|steering rack fitted\| \|2.2.A.1b\|	1
Nearside Side repeater not working \|1.4.A.2c\|	1
Nearside Front Hazard warning lamps not flashing in phase, with ignition on \|1.4.B.1f\|	1
Service brake: efficiency below requirements \|3.7.B.7\|	1
Nearside Front position lamp\|s\| incorrect colour \|1.1.A.3e\|	1
Offside Front position lamp\|s\| incorrect colour \|1.1.A.3e\|	1
Nearside Stop lamp not working \|1.2.1b\|	1
Offside Rear Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Nearside Rear Suspension component mounting prescribed area is excessively corroded \|2.4.A.3\|	1
Parking brake: efficiency below requirements \|3.7.B.7\|	1
Brakes imbalanced across an axle	1

MOT History from tests of petrol TOYOTA MR2s year 1984

Find us on Facebook