Most common failures | No# failures |
---|
Registration plate lamp issues | 9 |
Offside Rear fog lamp not working |1.3.2b| | 7 |
Windscreen wiper does not clear the windscreen effectively | 7 |
Brake pipe excessively corroded | 6 |
Headlamp aim out of alignment | 6 |
Exhaust has a major leak of exhaust gases |7.1.2| | 5 |
Brakes imbalanced across an axle | 4 |
Rear brake application uneven | 4 |
Offside Front position lamp|s| not working |1.1.A.3b| | 3 |
Nearside Rear Leaf spring has excessive wear in a shackle pin and/or bush |2.4.B.2| | 3 |
Exhaust system not adequately supported |7.1.1| | 3 |
Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 3 |
Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 3 |
Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 3 |
Offside Front Front position lamp|s| not working |1.1.A.3b| | 2 |
Brake hose damaged | 2 |
Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Offside Front Side repeater not working |1.4.A.2c| | 2 |
Nearside Front Shock absorber has negligible damping effect |2.7.5| | 2 |
Brake load sensing valve linkage defective and function impaired |3.6.E.3| | 2 |
Offside Rear Leaf spring fractured |2.4.B.1a| | 2 |
Horn not working |1.6.2a| | 2 |
Service brake: efficiency below requirements |3.7.B.7| | 2 |
Front Exhaust has a major leak of exhaust gases |7.1.2| | 2 |
Parking brake: efficiency below requirements |3.7.B.7| | 2 |
Offside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Nearside Front wheel bearing has excessive play |2.5.A.3c| | 2 |
Centre Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 2 |
Offside Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 2 |
Offside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 2 |
Nearside Front position lamp|s| not working |1.1.A.3b| | 2 |
Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 2 |
Nearside Front Anti-roll bar linkage fractured |2.4.G.1| | 2 |
Offside Front Shock absorber has an excessively worn bush |2.7.4| | 2 |
Offside Rear Leaf spring has excessive wear in a shackle pin and/or bush |2.4.B.2| | 2 |
Rear fog lamp tell tale not working |1.3.1b| | 1 |
Parking brake lever ratchet mechanism is broken |3.1.5| | 1 |
Offside Rear position lamp|s| excessively deteriorated so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Stop lamp not working |1.2.1b| | 1 |
Offside Side repeater not working |1.4.A.2c| | 1 |
Offside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Upper Suspension arm corroded and seriously weakened |2.4.G.1| | 1 |
Offside Rear Brake actuating linkage mounting prescribed area is excessively corroded |3.3.A.2| | 1 |
Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Centre Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Lower Suspension arm corroded and seriously weakened |2.4.G.1| | 1 |
Nearside Inner Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Inner Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Offside Rear Rear position lamp|s| incomplete |1.1.4a| | 1 |
All position lamps adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
Rear fog lamp excessively deteriorated so that it is not visible from a reasonable distance |1.3.2d| | 1 |
Offside Rear Rear position lamp|s| excessively damaged so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Track rod end ball joint has excessive play |2.2.B.1f| | 1 |
Offside Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
Fuel cap/sealing device sealing washer missing |7.2.4c| | 1 |
Nearside Front brake disc excessively pitted |3.5.1h| | 1 |
Nearside Ball joint has excessive play |2.2.B.1f| | 1 |
Offside Front Side repeater incomplete |1.5.A1b| | 1 |
Offside Front Shock absorber has negligible damping effect |2.7.5| | 1 |
Nearside Rear Leaf spring has excessive wear in an anchor pin and/or bush |2.4.B.2| | 1 |
Nearside Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
Nearside Rear Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake actuating linkage mounting prescribed area is excessively corroded |3.3.A.2| | 1 |
Nearside Rear Direction indicator incomplete |1.5.A1b| | 1 |
Parking brake lever has no reserve travel |3.1.6b| | 1 |
Nearside Front Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 1 |
Rear fog lamp switch faulty |1.3.1a| | 1 |
Exhaust emissions carbon monoxide content after 2nd fast idle excessive |7.3.D.3| | 1 |
Emissions not tested |7.0| | 1 |
Offside Headlamp aim beam image kick up to the offside |1.8| | 1 |
Brake hydraulic reservoir fluid level below minimum level |3.6.G.1b| | 1 |
Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
Offside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Offside Headlamp insecure |1.7.3| | 1 |
Nearside Side repeater not working |1.4.A.2c| | 1 |
Fuel system component insecure |7.2.1| | 1 |
Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
Nearside Front Statutory seat belt missing |5.1.1| | 1 |
Brake valve leaking |3.6.A.1| | 1 |
All position lamps not working |1.1.A.3b| | 1 |
Nearside Indicator tell tale inoperative |1.4.A.2a| | 1 |
Nearside Front front brake binding |3.7.B.1| | 1 |
Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Front Anti-roll bar linkage missing |2.4.G.1| | 1 |
Fuel tank insecure |7.2.1| | 1 |
Battery insecure |1.9.1| | 1 |
Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone `A` |8.3.1e| | 1 |
Offside Vehicle structure is damaged, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
Offside Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement |2.4.B.2| | 1 |
Offside Rear Wheel nut|s| missing |4.2.A.1e| | 1 |
Offside Front Anti-roll bar missing |2.4.G.1| | 1 |
Nearside Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Nearside Rear Leaf spring cracked |2.4.B.1a| | 1 |
Nearside Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Nearside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Rear Leaf spring has excessive wear in an anchor pin and/or bush |2.4.B.2| | 1 |
Vehicle structure has excessive corrosion which adversely affects braking or steering |6.1.A.1| | 1 |
Offside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
Nearside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Offside Front Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Rear Rear position lamp|s| incomplete |1.1.4a| | 1 |
Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Rear Stop lamp not working |1.2.1b| | 1 |
rear brakes release unevenly |3.7.B.4| | 1 |
Offside Rear Rear wheel bearing rough when rotated |2.6.1| | 1 |
Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
Nearside Rear Leaf spring fractured |2.4.B.1a| | 1 |
Offside Front Obligatory mirror seriously damaged, affecting the rear view |8.1.2a| | 1 |
Rear Brake load sensing valve linkage seized |3.6.E.3| | 1 |
Nearside Rear position lamp|s| incomplete |1.1.4a| | 1 |
Nearside Front wheel bearing rough when rotated |2.5.A.2| | 1 |
Exhaust has a part missing |7.1.1a| | 1 |
Exhaust tailpipe not capable of allowing the emission probe to be inserted |7.3.B.1| | 1 |
Nearside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Windscreen wiper blade deteriorated |8.2.2| | 1 |
Offside Front Front suspension has excessive play in a upper suspension ball joint |2.5.B.1a| | 1 |
Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
Nearside Front Anti-roll bar linkage insecure |2.4.G.1| | 1 |
Steering arm has relative movement at its fixings |2.2.B.1h| | 1 |
Nearside Front Front position lamp|s| excessively damaged so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Nearside Rear reflector excessively deteriorated so that its function is impaired |1.5.1c| | 1 |
Offside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
Nearside Parking brake mechanism/associated mounting prescribed area is excessively corroded |3.1.9| | 1 |
Nearside Front Suspension arm has excessive play in a pin/bush |2.4.G.2| | 1 |
Brake master cylinder/servo mounting prescribed area is excessively corroded |3.6.C.3| | 1 |
Nearside Rear reflector excessively damaged so that its function is impaired |1.5.1c| | 1 |
Nearside Front position lamp|s| excessively damaged so that it is not visible from a reasonable distance |1.1.A.3d| | 1 |
Offside Front Suspension has inadequate clearance with the bump stop |2.4.A.1a| | 1 |