| Most common failures | No# failures |
|---|
| Offside Rear fog lamp not working |1.3.2b| | 3 |
| Registration plate lamp issues | 2 |
| Exhaust emits an excessive level of metered smoke for a non-turbo charged engine |7.4.B.3b| | 2 |
| Nearside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 2 |
| Rear brake binding | 2 |
| Brake hose excessively deteriorated | 2 |
| Nearside Seat belt anchorage prescribed area is excessively corroded |5.2.6| | 1 |
| Nearside Rear position lamp|s| adversely affected by the operation of another lamp |1.1.A.3f| | 1 |
| Nearside Rear Direction indicator adversely affected by the operation of another lamp |1.4.A.2h| | 1 |
| Nearside Stop lamp adversely affected by the operation of another lamp |1.2.1f| | 1 |
| Nearside Rear Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Offside Front Shock absorber has a serious fluid leak |2.7.3| | 1 |
| Rear Exhaust system not adequately supported |7.1.1| | 1 |
| Brake cable locking device insecure |3.5.1l| | 1 |
| Nearside Headlamp aim beam image obviously incorrect |1.8.A.1b| | 1 |
| Nearside Front Braking system leaking |3.6.A.1| | 1 |
| Horn not working |1.6.2a| | 1 |
| Nearside rear brake recording little or no effort |3.7.B.5a| | 1 |
| Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement |2.4.G.2| | 1 |
| Nearside Front Suspension component mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Rear Rear fog lamp not working |1.3.2b| | 1 |
| Nearside Front Body has a projection caused by damage |6.1.C.1| | 1 |
| Nearside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Offside Front suspension has excessive play in a lower suspension ball joint |2.5.B.1a| | 1 |
| Nearside Front Subframe mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Nearside Front Subframe mounting prescribed area is inadequately repaired |2.4.A.3| | 1 |
| Offside Headlamp not in good working order adversely affecting beam image |1.2.4a| | 1 |
| Headlamp switch faulty |1.7.1| | 1 |
| Registration plate issues | 1 |
| Offside Inner Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings |6.1.B.2| | 1 |
| Nearside Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
| Offside Front Anti-roll bar linkage has excessive play in a pin/bush |2.4.G.2| | 1 |
| Vehicle Identification Number not permanently displayed |6.3.5.a| | 1 |
| All position lamps not working |1.1.A.3b| | 1 |
| Headlamp aim out of alignment | 1 |
| Brake pedal anti-slip provision incomplete |3.3.A.1b| | 1 |
| Nearside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Offside Rear Suspension spring mounting prescribed area is excessively corroded |2.4.A.3| | 1 |
| Brake load sensing valve linkage seized |3.6.E.3| | 1 |
| Offside Rear Brake lever has restricted free movement |3.5.1k| | 1 |
| Rear parking brake recording little or no effort | 1 |
| Brake master cylinder leaking hydraulic fluid |3.6.G.1f| | 1 |